Subscribe to Our Youtube Channel
Summary of Contents for Miro MRH5
- Page 1 MRH5 Wireless House Scene Remote Specifications Power Supply..Three AAA Alkaline Batteries, provided Operating Temperature ... 32°F to 104°F (0°C to 40°C)
-
Page 2: Unit Description
• Create a lighting trail and turn on a TV or radio so you can listen to the news as you go through your morning and evening routines. • Using the paddle’s “off” feature, turn off all Miro wireless devices with one touch as you leave the house. -
Page 3: New Installation
2. Verify that the newly added device LED is fl ashing green, indicating that it has acquired the House ID. In the case of the MRH5 or MRH6 handheld remotes, be sure that the unit is awake during the binding process. Press any button to activate the remote and illuminate its LED. -
Page 4: Operation
OPERATION When a new MRH5 is added to a system with existing house scenes, its scene buttons execute the same scenes as other house scene controllers with the same scene set assignment (see MORE SCENES). Paddle functions are the same at every house scene remote and house scene controller. - Page 5 5. Go around the house and adjust light levels by pressing and holding the devices that you want to adjust. 6. Return to the MRH5 used in step 1 and press and hold the same scene button until the LED fl ashes once (about 2 seconds). Scene recording for this button is complete.
- Page 6 • Switched (non-dimming) circuits on included devices turn on Record a PANIC State 1. Press on the MRH5 until its LED begins fl ashing (about 2 seconds). 2. Press the PANIC button . The LEDs on all the Wireless Miro devices begin to fl...
- Page 7 MORE SCENES You can increase the number of house scenes to 10 by adding a second MRH5 to the house, then changing the “scene set assignment” on one of them. The MRH5 scene set assignment is 1-5 when shipped. Changing the second MRH5...
-
Page 8: Battery Information
Normal operations such as dimming, switching, scene recall and scene light level modifications are not affected. When the configuration is locked, if the rocker paddle on any Miro wireless device is pressed and held (- -), the device’s LED flashes red, and the command is ignored. -
Page 9: Troubleshooting
I made a configuration mistake. I need to start over. To reset any Miro wireless device to factory default settings, press and hold - until the LED changes to solid yellow (approximately 10 seconds). During the process, the LED flashes yellow. When complete, it becomes solid yellow. -
Page 10: Fcc Notice
FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Need help?
Do you have a question about the MRH5 and is the answer not in the manual?
Questions and answers