Advertisement
The 60 Second Face Toner has 3 exercise programmes with 17
power intensity levels. Best results are achieved by varying the
programme used. We recommend using Programme 1 on day 1,
followed by Programme 2 on the day 2, followed by Programme 3
on day 3, then back to Programme 1 on day 4 and so on.
To begin with the pulses give a mild tingling sensation and as the
intensity is increased you will notice muscle contractions. The muscle
contractions are smooth and each contraction will start with a slow
rise, hold itself in a contracted position for a few seconds and then
gently relax. We recommend starting on a low power level on each
treatment area and building up until muscle contractions are felt.
PROGRAMME 1 - FIRMING
Rhythmic muscle contractions to condition muscles with a short
interval between each pulse.
PROGRAMME 2 - EXTENDED FIRMING
This
offers
an
extended
muscle
contraction
with
pre-programmed varying intensity to maximise the workout.
PROGRAMME 3 - TAP TONING
Rapid stimulating action.
60 SECOND FACE TONER
TM
STEP 1
Apply a generous amount of conductive gel to each
of the ball contacts. Apply plenty of conductive gel to
ensure good contact with the skin.
STEP 2
Turn the unit on by pressing the programme/on/off
button, the light will turn green. The unit will start in
programme 1, the programme/on/off light will flash
once.
Note: To select programme 2, press the programme/
on/off button once more. The green light will flash
twice to indicate programme 2 is selected.
To select programme 3, press the programme/on/
off button once more. The green light will flash three
times to indicate programme 3 is selected.
STEP 3
Onto clean skin, position both ball contacts for
treating the first area.
6
STEP 4
Increase power by pressing the (+) button and
•
Your teeth may feel slightly sensitive during treatment, this is
move the position of the ball contacts if necessary
perfectly normal.
until you feel definite muscles contractions. If this is
uncomfortable, decrease power by pressing the (–)
•
Effective face toning and firming is based on a light and
button.
gentle stimulating massage on your face muscles. Should you
experience any discomfort, you should add more conductive
Note: You will need to adjust the intensity level
gel, reduce the intensity by pressing the (-) button, or remove
when treating different areas of the face.
the unit from the area being treated.
•
Start at a low level to begin with until you get used to the
sensation.
STEP 5
•
The forehead requires higher intensity levels. Press the (-) button
Hold the unit in position for 60 seconds to complete
several times before returning to the facial area.
treatment of the area.
After 60 seconds, reduce the power level before
moving onto the next treatment area.
STEP 6
After use, switch the unit off. Press and hold the
Programme/On/Off button for 2 seconds.
Note: If unit is left on, it will automatically switch off
after 10 minutes.
7
HANDY TIPS
60 SECOND FACE TONER
TM
Advertisement
