Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for TSS KEETEC BS 400
- Page 1 KEETEC BS 400 KEETEC BS 400 LED USER'S MANUAL...
-
Page 2: General Installation Diagram
GENERAL INSTALLATION DIAGRAM MAIN UNIT Speed signal (for back system, no use) Back system Control box Foot brake (for back system, no use) Ground (same as front system) Power (same as front system) Display Turn on/off switch Control box Display Reversing light Sensitivity adjustable DIP SWITCH OF MAIN UNIT... -
Page 3: Display Status
Back system DISPLAY STATUS Safety Area 110-150cm Front system Bi……Bi…… Safety Area 70-100cm Alarm Area 40-100cm Bi……Bi…… Alarm Area 40-60cm Bi…Bi… Bi…Bi… Danger Area 0-30cm Danger Area 0-30cm Bi…… Bi…… Danger Area 0-30cm Danger Area 0-30cm Bi…… Bi…… DETECTING RANGE Back of display Back system Side View... -
Page 4: Installation Tools
SENSOR INSTALLATION DIAGRAM Smooth slope Smooth round objects Objects absorbing wave, e.g.cotton Objects hard to be detected INSTALLATION TOOLS Be sure no other part of vehicle falls into detecting range of sensors. 0.6-0.8m 0.3-0.4m The best position for 2-sensors The best position for 4-sensors The direction of sensors(1) Insert-in 1. - Page 5 5. Sensor Installation 2. Select drilling position for sensor A & D A. Insert the sensors B. Hide the into the holes one by wires in good one and tighten them. A. Choose suitable drilling position order according The sensor with metal for A &...
-
Page 6: Installation Steps
INSTALLATION STEPS H-123 consists of ultrasonic sensors, digital control unit and display. This system detects 1. Choose right installation position for sensors 5. Install the sensors and hide the wires the distance between the car and back obstruction by the ultrasonic sensors installed at the 6.
Need help?
Do you have a question about the KEETEC BS 400 and is the answer not in the manual?
Questions and answers