User Manual Safety Precautions Before using the product, please ensure that you read the safety precautions described below. Always ensure that the product is used correctly. Use only recommended power sources. Do not attempt to disassemble, alter or apply heat to the product. ...
User Manual Index Features ........................1 Specifications ....................... 2 OSD Operation ......................4 Main menu ........................4 AE Mode Setting ....................5 Color Adjust ......................9 Image Adjust...................... 10 Intelligent ......................14 System setting ....................17 Information......................18 Attachment A: UTC Controller Installation ................19...
User Manual A. Features 1/3” 5 Mega Pixel Color Camera 2D/3D Noise Reduction (HDNR) Optics Double Frequency WDR(128dB) Digital Slow Shutter from x2 up to x512 (Max) Adaptive Backlight compensation function ( BLC ) / Anti-Headlight (HLC) ...
User Manual B. Specifications Video System NTSC / PAL Pick Up Element 1/3” 5 MegaPixel Image Sensor Image Signal Process Digital Signal Processor Number OF Pixels 2592 (H) × 1920 (V) Picture Elements Approx. 5000K Power Supply DC +12V Power Consumption 530 mA Synchronization Internal Synchronization...
Page 6
User Manual Color / B&W (D&N) digital day & night mode /Auto-Progressive/Auto-General/External input Motion detecting function on / off (Multi object tracking D-Zoom x 4) Flash suppression function on / off Privacy masking function on / off (8 Editable area) Blemish Compensation Static &...
User Manual C. OSD Operation Main menu OSD Setup Setup: 1.Click one time to enter the Main menu Click twice ( to Exit OSD menu, Reload Fty , Return to Previous page, Exit & Save) UP / Down: Selection.
User Manual (1) AE Mode Setting Standard AE Under Standard mode AE, symbol will be shown on the upper left corner of Live view. Smart WDR:Value 0~3 Frame Rate:Indoor/ Outdoor Standard SWDR...
Page 9
User Manual Back light compensation Level: (Auto, Low, Middle, High) Symbol will be shown on the upper left corner of Live view. Normal Back light compensation...
Page 10
User Manual High light compensation Set Range: Click Right button to enter the menu, press SETUP button in order to set up next corner point. (in this area, any brighter light source will be blocked) Normal HLC on Detection are (area marked in Red) ...
Page 11
User Manual Demist Demist: Set the level of Demist. If set Auto, the DSP will turn on/off the function and decide the level of demist (Auto, Low, Middle, High). 3D-NR: On/Off the 3D-NR function Symbol will be shown on the upper left corner of Live view Normal Demist activated (Heavy Fog) Demist Off...
User Manual (2) Color Adjust Color adjust settings White Balance Tracking Mode 2-8.5k、Tracking Mode 2-10k Brightness 0~99 Color-Red Red (0~99) Color-Green Green (0~99) Color-Blue Blue (0~99) Contrast 0~99 Saturation 0~99 CR suppress ON/OFF...
User Manual (3) Image Adjust Image adjust settings 1. Day & Night Mode: Auto-Progressive Like human eyes...
Page 14
User Manual Mode: B/W Change to B/W mode Color burst: On/Off Color burst Mode: Color Change to Color mode. Mode: Ext For external control, the input pin is the PIO 0 on the PCB board. i. Color burst On/Off Color burst ii.
Page 15
User Manual Set Input level (High, Low) to make it work! iii. Smart IR Set 0~6 to adjust the curve of brightness to prevent overexposure/underexposure of image blocks. iv. IR CUT Output Via GPIO 3, output high/low level for IR-CUT use. ...
Page 16
User Manual 2. Digital Slow Shutter 1/100000,1/10000,1/5000,1/2000,1/500,1/240,1/120,1/60, AUTO,2x,3x,4x,5x,8x,16x,32x,64x,128x,256x,512x To extend the photoperiod in order to enhance the sensitization. It will help to have brighter images in a condition with lack of light. Slow shutter OFF Sow shutter ON 3. HDNR HDNR (0~32) HDNR On/Auto Clearly HDNR OFF:...
User Manual (4) Intelligent Intelligent surveillance setting Multi object tracking Sensitivity (-4~4) Warning trigger Level: (High/Low/Off) An alarm outputs when a motion is detected. Default output port: PIO2. Alarm time (0~3600) D-Zoom Set Zoom factor (1.0~4.0) ...
Page 18
User Manual (0~15) Hot Zone Display ON/OFF, Symbol will be shown on the upper left corner of Live view. Normal Multi object tracking On D-Zoom D-Zoom: Set Zoom factor(1.0~4.0) Tilt: When using D-Zoom, adjust the tilt degree, value (-10~10) ...
Page 19
User Manual Privacy Mask Opacity (0~3), Mask transparency setting. Mask Select (1~8), Select and set up the mask, maximum 8. Set Mask Area Mask range set up (click Right button to set up) Switch ON/OFF Mask Color (0~65535) , Masks color setting ...
User Manual (5) System setting System setting Lens Mode: To select lens type, DC in door/ DC outdoor/ Manual. Brightness: only be activated with DC IRIS (-50~50). Aperture speed: only available for Lens of DC IRIS (0-7) ...
User Manual Monitor selection Select monitor: LCD/CRT Brightness: set the brightness level(0~37) Others Mirror: Horizontal/Vertical/Off Show ID/Icon: OFF/ Show ID/Icon/ Show ID/ Show Icon (6) Information Display Version Information...
User Manual Attachment A: UTC Controller Installation UTC Controller (optional)
Page 23
FUHO TECHNOLOGY Co., LTD No. 30, Lane 726, Jinma Rd, Sec. 3, Chang Hua City, Taiwan. TEL:886-4-751-2881 FAX:886-4-751-5860 Made in Taiwan http://www.vacron.com...