VIETA VHP-WB600 User Manual page 6

Introduction
This Bluetooth wireless headphone applies the BT 2.1 wireless technology platform that enables you
to enjoy music and video and cell phone handsfree calling anywhere inside or outside your home.
Packaging
1. Bluetooth stereo headphone
2. 2.5mm to USB charging cable
3. 3.5mm to 3.5mm audio cable
Features
1. Bluetooth 2.1 Platform
2. A2DP profile
3. Hands free telephone calling
4. Stereo music
5. Operating distance up to 10 meters
6. Auto Shut-Off
7. Operation time up to 10 hours (median volume
level)
8. Line-in function for wired headphone
application
Component Identification
1. Power LED Indicator
2. Power / Pair / Talk
3. Volume+, Volume -
4. 3.5mm Audio In Jack
5. 2.5mm Charge in Jack
6. Microphone
7. NFC
10
Pairing
1. Press the Power button, the LEDs indicator
light will be on. Keep pressing the power button
until the LED flashes in blue.
2. Enable your Bluetooth device such as cell
phones, tablets or other BT media, and make
sure it is at searching mode.
3. Choose "Vieta VHP-WB600BK /
VHP-WB600WH" in the list shown in the BT
device, enter "0000" if password is required.
4. When Bluetooth connection is made, the LED
will flash slowly.
5. Listen your music or make/take your telephone
call on the headphone
6. The transmission is approx. 10 meters.
When the paired receiver is out of range
from BlueTooth device, it will disconnect. The
transmission will be resumed by pressing the
power button on the receiver within the
operating range.
Alternatively, pairing by One-touch
connection with Near Field Communications
(NFC)
1. Press the power button and keep pressing
until the blue LEDS flashes, the headphone will
enter pairing mode immediately.
2. Enable your Bluetooth device such as cell
phones, tablets or other Bluetooth media.
3. Make sure the NFC is enabled in your device.
4. Use your NFC enabled device and touch
the NFC logo on the speaker (as shown in the
diagram) , a "beep" sound indicates pairing is
successfully done.
5. When Bluetooth connection is made, blue LED
will flash slowly.
Bluetooth NFC Stereo Headphone
Note: To re-enter to pairing mode after the
headphone is on, you need to switch off the
headphone and restart it by doing step 1.
Charging
1. Make sure the headphone is fully charge
before initial use.
2. Connect headphone with your PC by the
supplied 2.5mm to USB cable for charging.
3. Charging is workable to connect with other
power adapter with USB jack at 5V 500mA
specifications.
4. The charging LED will illuminate when
charging is under processing. Charging will be
finished when LED becomes Green.
Telephone Call
1. If there is an incoming call when streaming
music on headphone, the music will be muted
and ring tone will be heard.
2. Take your call by pressing the Power/Pair/Talk
button. Press once again when ending the call.
Music will come out again automatically.
3. To make a call, simply dialing at your cell
phone, and talk at the headphone.
*Check the instruction manual for your cell
phones, if getting any process different from the
above.
Line-In
1. Connect the headphone with your audio
device directly by the supplied 3.5mm cable
2. The Bluetooth wireless music will be by pass
after line-in connection is made
11 ENGLISH