Related Manuals for SAFE-TECH kd67x_16
Summary of Contents for SAFE-TECH kd67x_16
-
Page 1: Digital Video Recorder
DIGITAL VIDEO RECORDER QUICK START Please read instructions thoroughly before operation and retain it for future reference. KD678_677_676_675_AC758D_757_756D_755_CD536_538_V1.0... -
Page 2: Special Notes
SPECIAL NOTES 1. SPECIAL NOTES Remote Surveillance 1). This DVR series supports remote independent operation, and the image transmission per channel is independent at the remote site. Therefore, during the remote surveillance, the image transmission may not be so fluent when you’re viewing four channels or more at the same time. 2). -
Page 3: Front And Rear Panel
2. FRONT AND REAR PANEL 2.1. Front Panel 1) LED Indicators POWER : DVR is powered on. : HDD is reading or recording. ALARM : An alarm is triggered (Selected models only). TIMER : Timer recording is on. PLAY : Under playback status. 2) MENU Press to enter the main menu. -
Page 4: Connection And Setup
16) EJECT (Selected models only) Press to open / close the built-in DVD Writer. 17) “MENU” + “ENTER” (Key lock) Press these two buttons at the same time to lock keys on the DVR front panel. Press any button on the DVR front panel and enter the DVR password to exit the key lock mode. 2.2. -
Page 5: Camera Connection
installation process may vary depending on different models and situations. Step 1: Loose the screws on the upper cover and open the upper cover of the DVR. Note: The DVR cover is made of metal. Please be careful with its edge when you remove the cover. Step 2: Remove the HDD bracket. -
Page 6: Basic Operation
3.5. Date and Time Setting Before operating your DVR, please set the date and time on your DVR first. Press “MENU” and enter the password to go to the menu list. The default admin password is 0000. Move to “DATE” and you can set the date / time / daylight saving in the “DATE” menu list. Note: Please DO NOT change the date or time of your DVR after the recording function is activated. - Page 7 for continuous recording without notice. Manual Recording Icon By defaults, when the DVR is properly connected with cameras and the HDD is installed, you can see “ ” (recording) on the screen. Event Recording Icon When the motion / alarm detection is activated, once motion or external alarm happens, you will see “ ”...
-
Page 8: Firmware / Osd Upgrade
Then, click “Play” to immediately start playback. 4.4. Search Via DVR Full Event Search Press “LIST” to show the list for all types of the recorded files. Choose the item you want to see and press “ENTER” to start playback. Search by Time Press “MENU”...