J | Trouble Shooting - Kibernetik Nanyo 25aa Operating Manual

OPERATING MANUAL | Air Conditioner Nanyo 25AA
I | STORAGE
1. Empty the internal water container (refer to Chapter F)
2. Clean and replace the filter (see also chapter D).
3. Put the unit in air circulation mode for 2 hours to ensure that the inside
becomes completely dry.
4. Store cable as shown, protect the unit against dust and store in a dry
place.

J | TROUBLE SHOOTING

Problem
The unit does not function
The unit does not seem to
perform
The unit is noisy
The compressor does not
work
Remote control does not
function
Never try to repair or dismantle the air conditioner yourself. Incompetent repairs result in
loss of warranty and can endanger the user.
42
Cause
No power supply
Water tank indicator is on
In direct sunlight
Windows or doors open,
many people or heat
source in room
Dirty filter
Air inlet or air outlet locked
Room temperature lower
than selected value
Unit stands uneven
Overheat protection
probably activated
Distance too great
Remote control signal not
detected by control panel
Batteries empty
Solution
Connect to a functioning
outlet and switch on
Empty the internal water
container
(refer to Chapter F)
Close curtains
Close doors and windows,
or place an extra air
conditioner
Clean filter.
Remove blockage
Change temperature
selection
Place on even surface
(less vibrations)
Wait 3 minutes until the
temperature has
decreased, and turn on the
unit again
Make sure the remote
control is correctly aimed at
the control panel < 5m
Replace the batteries