Ross RPPHA150MM Instruction Manual
  1. Manuals
  2. Brands
  3. Ross Manuals
  4. Lawn and Garden Equipment
  5. RPPHA150MM
  6. Instruction manual

Ross RPPHA150MM Instruction Manual

Post hole digger 49cc 150mm
Hide thumbs
1
2
3
4
5
Table of Contents

Advertisement

Quick Links

Download this manual
IN S T R U C T ION MA N U A L
R P P HA 1 5 0 MM
P O S T HO L E D IG G E R 4 9 C C 1 5 0 MM
Protect yourself and others by observing all safety information, warnings,
and cautions. Failure to comply with instructions could result in personal
injury and/or damage to product or property.
Please retain instructions for future reference.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RPPHA150MM and is the answer not in the manual?

Questions and answers

Summary of Contents for Ross RPPHA150MM

  • Page 1 IN S T R U C T ION MA N U A L R P P HA 1 5 0 MM P O S T HO L E D IG G E R 4 9 C C 1 5 0 MM MO D E L 8 9 0 6 3 MO D E L 8 9 0 6 3 MO D E L 8 9 0 6 3...

  • Page 2: Technical Specifications

    Introduction To get the most out of your new earth auger, please read these instructions and the attached safety instructions before use. Please also save the instructions in case you need to refer to them at a later date. Technical specifications. Stroke volume: 49 cm Motor power output:...
  • Page 3 Special safety instructions Never start the motor without the air filter in place or if the silencer is defective. The motor uses lubricated petrol. Never use pure Always follow the motor maintenance instructions leaded petrol, diesel or other fuels. under “Cleaning and Maintenance”. The petrol must be a mixture of 1 part two-stroke Beware that the earth auger may vibrate violently oil to 25 parts unleaded 95-octane petrol.
  • Page 4 Connecting the auger and gearbox Slot the auger shaft over the motor shaft, ensuring the holes in the shafts line up with one another. Push the cotter pin (f) through the holes and secure it with a bendable pin (e). Assembling the auger and gearbox...

  • Page 5: Cleaning And Maintenance

    Starting and stopping the motor Cleaning the spark plug Remove the spark plug using a spark plug spanner. Cold motor start: Remove any deposits using a wire brush. Check Set the starter switch (8) to the run position. that the spark gap is 0.6 to 0.7 mm and adjust if necessary.

Table of Contents