Table of Contents
Advertisement
Quick Links
Swissvoice IP10S SIP Image Phone
Distributor Guide
Revision
Revised By
Initial
Tigran Avanesov
Artashes Ter-Vardanyan
Quadro
variants:
valid for
SW-version:
tested with
SW version:
Filename:
MGCP config for SwissVoice IP10
Distributor guide.doc
Version:
1
Template:
SupportTemplate.dot
Last saved:
28.10.2004 19:07 by
Abstract: This document presents step-by-step how to pre-configure
the SwissVoice IP10S SIP image phone to work together
with Quadro.
Swissvoice IP10S Phone Distributor Guide
Date
26 Oct 2004
11 Nov 2004
Advertisement
Table of Contents
Related Manuals for Epygi SwissVoice IP10S
Summary of Contents for Epygi SwissVoice IP10S
- Page 1 SW-version: tested with SW version: Filename: MGCP config for SwissVoice IP10 Distributor guide.doc Version: Template: SupportTemplate.dot Last saved: 28.10.2004 19:07 by Abstract: This document presents step-by-step how to pre-configure the SwissVoice IP10S SIP image phone to work together with Quadro.
- Page 2 Software ..............3 2.3.2 Hardware ..............3 Configuration .................4 Initial Configuration ............4 End User Configuration............5 Quadro Configuration ..............6 Configuring the IP Lines ............6 Appendix A SwissVoice Config Files..........7 File swupdate_ip10.inf ............7 File swissvoicesip.cfg ............7 Copyright © 2004 Epygi Technologies, Ltd. All rights reserved.
-
Page 3: Requirements And Preparations
Swissvoice IP10S Phone Distributor Guide 1 Introduction This User Guide offers step-by-step instructions for the configuration of a Swissvoice IP10S phone to work together with a Quadro. 2 Scenario 2.1 Objectives of the scenario 2.2 Abbreviations • DNS Domain Name Server •... -
Page 4: Initial Configuration
TFTP server. Then the idle screen is displayed. The phone is provisioned. Caution : The power supply must not be interrupted during the boot session. The phone could be damaged. Copyright © 2004 Epygi Technologies, Ltd. All rights reserved. -
Page 5: End User Configuration
If Quadro’s LAN IP address has been changed, the user has to either make the corresponding changes in the network and SIP configuration of the phone. To perform phone setup, see SwissVoice IP10s User Guide. Copyright © 2004 Epygi Technologies, Ltd. All rights reserved. - Page 6 SIP phone to be connected to the Quadro’s LAN. Username Password are required to be inserted for this selection, which should match on both Quadro Phone successful connection establishment. Copyright © 2004 Epygi Technologies, Ltd. All rights reserved.
- Page 7 172.30.0.1 5060 set rtp_prof dtmf_relay inb 101 set sip register_timeout 3600 set sip refer_timeout 3600 set utilities sntp_mode request set utilities sntp_srv_ipaddr 172.30.0.01 set utilities sntp_rqnt_freq 1 0 Copyright © 2004 Epygi Technologies, Ltd. All rights reserved.
Need help?
Do you have a question about the SwissVoice IP10S and is the answer not in the manual?
Questions and answers