Advertisement
Set up your Gateway
2
1.
Decide the location for the Gateway.
Put the Gateway in a location where air can circulate freely around it.
2.
Connect the power supply to the power jack on the back panel of the Gateway.
Then, plug the power supply into an electrical outlet. Turn on the Power switch.
The
Power
light should light solid green.
3.
Insert the Netopia CD into your CDROM drive.
The Netopia Installation Guide Wizard automates several tasks to get you up and running easily. You can
run the Wizard on every Windows-based PC that will connect to your network.
The Installation Guide Wizard will run automatically and step through your connection installation(s).
Follow the on-screen instructions to make all of your connections.
Configure Your PCs for DHCP
3
Be sure to configure each computer connected to your Netopia Gateway to accept a Dynamically-assigned IP
address, commonly referred to as DHCP.
The Installation Guide Wizard lets you choose which type
of Netopia device you are installing, and where you are
installing it. Choose either Install via Ethernet or
Install USB Connection . The Netopia Installation
Guide Wizard will install USB drivers if you choose the
USB option.
Click the Next button.
When all of your connections are made, your connections should look like this:
Telephone/DSL jack
2
Connect via Ethernet or USB.
Note:
You will need an extra hub or switch if more Ethernet ports are needed.
Front View
Power
Ethernet
Internet
2
Rear View
USB Port
DSL Port
Ethernet
Power Switch
Port
OFF
RESET
ON
USB
ETHERNET
POWER
DSL
2
(optional)
Power
Ethernet
DSL
USB
LED
Behavior
Green
when power is on.
Red
if device malfunctions.
Solid
green
when connected. Flashes
is activity on the LAN.
Solid
green
when connected. Flashes
USB
is activity on the LAN.
Solid
green
when Internet connection is established.
DSL
Solid
green
when Gateway is connected. Flashes
when transmitting or receiving data on the WAN port.
Power outlet
DC Power
Internet
green
when there
green
when there
green
3
Advertisement
