Advertisement
Quick Links
Advertisement
Summary of Contents for SE SRM Series
- Page 1 Manual SRM Series Manual Pull-Down Projection Screen USER’S GUIDE...
- Page 2 Pre-installation 1. Carefully unpack the screen. 2. Always handle the screen in a leveled position on a clean surface. INSTALLATION Flush Wall Mounting 1. Mark the location of where the screen is to be installed for the pre-drilled hole. 2. After marking the area and drilling the hole, insert the proper screw into the drilled hole and leave about 1/8”...
- Page 3 Note: Always pull the screen down or let it up in a 90-degree vertical angle. Do not allow the screen to touch the screen case when the screen goes up or comes down to avoid damaging the screen material. 1. Pull the screen down from the lanyard or from the handle only in a 90-degree angle. Do not attempt to pull the screen down by the surface or touch the screen, as it will damage the screen and void the warranty.
- Page 4 The installer must insure that the fasteners used are of adequate strength and suitable for the mounting surface chosen. Manual SRM Series Dimensions Table Unit: mm...