Table of Contents
Advertisement
Remote Keyless Entry Transmitter (Key Fob)
Unlock
Press to unlock the driver's door.
Press again to unlock all doors.
Lock
Press to lock all doors.
Note: Press and hold the Lock/Unlock buttons to
automatically fold/unfold the power mirrors
To change the Auto Mirror Folding setting, go to
Comfort and Convenience in the Vehicle Settings
menu.
Liftglass
F
Press twice to open the liftglass.
Power Liftgate
Press twice to open or close the power
liftgate.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle.
The turn signal lamps will flash and the
horn will sound.
Press and hold to activate the alarm. The
turn signal lamps will flash and the horn
will sound until the button is pressed
again or the ignition is turned on.
Power Liftgate
Open/Close the Power Liftgate
Press the
Power Liftgate button on
the RKE transmitter twice.
Press the
Power Liftgate knob on
the overhead console.
Press the touchpad on the liftgate han-
dle to open the liftgate.
Press the button next to the liftgate
latch to close the liftgate.
Hands-Free Operation
To open or close the liftgate hands-free,
kick your foot straight in and out under
the center of the rear bumper. Do not
swing your foot side-to-side. The RKE
transmitter must be within 3 feet of
the liftgate.
4
F
Optional equipment
F
F
F
Remote Vehicle Start
Press and release the
and then press and hold the
until the turn signal lamps flash (about
4 seconds) to start the engine from out-
side the vehicle. After entering the vehicle,
turn on the ignition.
F
.
• During a remote start, the engine will
run for 10 minutes.
• Remote Start can be extended once by
repeating the remote start procedure.
• Press and hold the
the parking lamps turn off to cancel a
remote start.
• The heated/cooled seats
during a remote start (if selected in the
Vehicle Settings menu) when outside
temperatures warrant.
Note: To change the remote lock, unlock, and
remote start settings, go to Remote Lock, Unlock,
Start in the Vehicle Settings menu.
See Keys, Doors and Windows in your Owner Manual.
Programming the Liftgate Height
1. Turn the Power
Liftgate knob to the
3/4 mode position.
2. Open the liftgate.
3. Adjust the liftgate
manually to the
desired height.
4. To save the setting, press and hold the
button next to the liftgate latch for
3 seconds. The turn signals will flash
when the setting is saved.
See Keys, Doors and Windows in your Owner Manual.
F
Lock button
button
button until
F
will turn on
Advertisement
Table of Contents
