Status; Device Config; Factory Reset - SoundCraft Vi DANTE User And Setup Manual

Status: The Status tab is used to view information
about a Dante device, this information may be
required for trouble shooting and checking software /
firmware is up‐to‐date.
Factory Reset: Allows remote reboot of the Dante interface and to reapply factory settings. Following
a reboot it is recommended to power‐cycle the console including disconnection of the AC power
cord. Factory Reset wipes the following device configuration settings:

User‐defined device name

User‐defined channel labels

Clock configuration (clock master / external clock master setting)

Static IP addresses

Redundancy configuration

Sample rate setting (including pull‐up/down)

Latency setting

Any existing audio routes
Vi Dante Card User & Setup Guide V1.1
Device Config: This tab on the device view allows
viewing and editing of the following device specific
parameters.
Rename Device: Allows renaming of the Dante device.
Sample Rate: 48K – this is fixed and cannot be edited.
Latency: Allows selection of an appropriate latency.
NOTE: The 0.15 msec setting is unavailable on Vi
Dante cards as these include an internal switch.