Filter Cleaning - Bionaire BAP600 Series Instruction Manual

To reinstall the permanent filter after cleaning:
1. Install the clean filter into the air purifier housing
and replace the base air inlet grill. To install the base
air inlet grill back onto air purifier housing, hold the
handle at the base grill, and turn clockwise until the
Lock icon ( ) is aligned with the indicator mark
below the power cord outlet on the rear side of the
air purifier housing. Ensure the base air grill inlet
(swap order) is locked securely in place (see Fig. 4).
2. To reset the Filter Check Indicator, press and hold the
Filter Reset Button ( ) for 3 seconds while the unit
is operating (in any speed). The light will flash 3
times and then go off. The filter check timer is now
reset.
NOTE: Should your filter become damaged or lost, new
filters can be purchased at a retailer near you, online at
www.bionairecanada.com, or by calling 1-800-253-2764.
F I LT E R C L E A N I N G
Fig. 4
Base Air
Inlet Grill
Base Grill
Handle
LOCK
Air Purifier
Housing
Power Cord Outlet
Power Cord
Cleaned Permanent
HEPA-type Filter
BASE AIR INLET GRILL
(CLOSE-UP)