1. Manuals
  2. Brands
  3. MHSC Manuals
  4. Wood stove
  5. Windsor WR300007
  6. Owner's manual

MHSC WR300007 Owner's Manual

Hide thumbs Also See for WR300007:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
Windsor High Efficiency Wood
SafEty NOticE: if tHiS appliaNcE iS NOt pROpERly iNStallEd, OpERatEd aNd MaiN-
taiNEd, a HOuSE fiRE May RESult.
tO REducE tHE RiSk Of fiRE, fOllOW tHE iNStallatiON iNStRuctiONS. failuRE tO
fOllOW iNStRuctiONS May RESult iN pROpERty daMagE, bOdily iNjuRy OR EvEN
dEatH. cONtact lOcal buildiNg OfficialS abOut REStRictiONS aNd iNStallatiON
iNSpEctiON REquiREMENtS iN yOuR aREa.
This manual describes the installation and operation of the Model WR300007 non-catalytic wood heater.
This heater meets US Environmental Protection Agency's emission limits for wood heaters. Under specific
conditions this heater has been shown to deliver heat at rates ranging from 11,800 to 32,300 BTU/hr.
This stove is listed by OMNI-Test Laboratories of Port-
land, Oregon to meet UL1482 for the US and ULC-627
for Canada
do Not discard this Manual: Retain for future use
Stove
Model WR300007
Owner's Manual
6" flue required
30005127 1/11 Rev. 3

Advertisement

Table of Contents
loading

Related Manuals for MHSC WR300007

Summary of Contents for MHSC WR300007

  • Page 1 OfficialS abOut REStRictiONS aNd iNStallatiON iNSpEctiON REquiREMENtS iN yOuR aREa. This manual describes the installation and operation of the Model WR300007 non-catalytic wood heater. This heater meets US Environmental Protection Agency’s emission limits for wood heaters. Under specific conditions this heater has been shown to deliver heat at rates ranging from 11,800 to 32,300 BTU/hr.

  • Page 2: Before Installation Of Your Appliance

    Windsor High Efficiency Wood Stove Today’s solid fuel appliances are much more efficient cautiON than in the past. The units are designed to give you After reading these instructions, if you have any doubt controlled combustion, as well as maximum heat trans- about your ability to complete your installation in a fer, using less fuel to do so.

  • Page 3: Installation

    Windsor High Efficiency Wood Stove installation Ceramic Baffle Contact your local building inspector prior to installa- Figure 2 tion. A permit may be required in your area. Brick Placement 1. Remove all parts from inside the stove body. 2. Select the proper location for the stove. These ap- pliances must not be installed any closer than the Refractory minimum clearance to combustible materials.

  • Page 4: Floor Protection

    Windsor High Efficiency Wood Stove floor protection mm) higher than any point of the roof within 10 feet (3 m). installation on a concrete floor 4. The chimney connector shall not pass through an An appliance mounted on a concrete floor does not attic, roof space, closet, concealed space, floor, ceil- require floor protection.

  • Page 5: Building A Fire

    Windsor High Efficiency Wood Stove is the paint should be cured slowly. Avoid hot fires inlet air control Settings during the curing process. desired inlet **approx. During the curing process the paint will be gummy. burn Setting air Setting btu Output Once cured the paint will remain hard.

  • Page 6: Ash Disposal

    Windsor High Efficiency Wood Stove The following steps should be followed for door gasket WaRNiNg: things to remember in case of chimney replacement: fire: 1. close draft control. 2. call the fire depart- 1. Ensure appliance is not in operation and has thor- ment.
  • Page 7 Windsor High Efficiency Wood Stove adding small pieces of seasoned (dry) firewood, 7. is it normal for soot to cover the glass at the beginning of a fire? keeping the door slightly open until each piece starts to ignite. Remember to always open the Your stove has been built with an air wash system door slowly when placing wood into the fire.
  • Page 8 Windsor High Efficiency Wood Stove c. cold chimney temperature 10.Should i close or open the air control fully when shutting down the stove? Avoid cold chimney temperatures by burning a hot fire for the first fifteen to forty minutes, being When shutting down the stove, fully open the air careful not to over fire.
  • Page 9 Windsor High Efficiency Wood Stove 11 11 14 11 MHSC reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. WR300007 Wood Stove item No. description qty. part No.

  • Page 10: Year Warranty

    2. The new MHSC product must be installed and operated at all instructions. times in accordance with the installation and operation instruc- •...
  • Page 11 Windsor High Efficiency Wood Stove MHSc 149 Cleveland Drive • Paris, Kentucky 40361 www.mhsc.com 30005127...

Table of Contents