Type-Dependent Attributes - NETGEAR NMS100 Reference Manual

Reference Manual for the ProSafe Network Management System NMS100
Table 3-1. Object Properties Access tab
Attribute Name
Read/Write Community
Trap Community
V3 Engineid
V3 Context Name
V3 No Auth Security Name
V3 Auth/Priv Security Name
V3 Auth Password
V3 Priv Password

Type-Dependent Attributes

1. Select the Attribute tab to set type-dependent
attributes. For a complete description of all type-
dependent object attributes, please see
Object Properties Attribute tab.
2. To change an attribute, first select the attribute
name in the Attrib table. The selected attribute
name is displayed in the Name box and the current
value in the Value pull-down control.
3. In the Value pull-down, select one of the pull-down
values or type in a new value.
• Note that the Value pull-down does not
necessarily show all possible values for the
attribute. Use the >> button to show an
expanded selection mechanism for the selected
attribute value.
• When editing multiple objects, any attribute that has a different value for different objects
is shown as #####. Changing these attributes will set the new value for all selected
objects.
3-8
Description
The Community name used for SNMP V1/V2c operations when the
Read/Write Access Mode is used.
The Community name expected in a received SNMP V1/V2c Trap
frame. This is used to match an incoming trap to a map object.
SNMP V3 Engine Identifier (detected automatically).
VSNMP V3 Context Name (normally blank).
SNMP V3 Security Name to use with the noAuth access mode (no
authentication, no privacy).
SNMP V3 Security Name to use with authenticated or private
(encrypted) access modes.
SNMP V3 password to use for authentication.
SNMP V3 password to use for privacy (encryption).
Table 3-2
September 2004 202-10058-01
Data and Statistics