NETGEAR DG814 DSL Reference Manual page 61

Table 6-1. Menu 3.2 - System Status Fields
Field
DHCP
LAN Port
IP Address
IP Subnet Mask
DHCP
Modem
ADSL Firmware Version
Modem Status
Connect Mode
Down Stream
Up Stream
VPI
VCI
Maintenance
Reference Manual for the Model DG814 DSL Modem Internet Gateway
Description
If set to None, the gateway is configured to use a fixed IP address on the
WAN.
If set to Client, the gateway is configured to obtain an IP address
dynamically from the ISP.
These IP parameters apply to the Local (WAN) port of the gateway.
This field displays the IP address being used by the Local (LAN) port of
the gateway. The default is 192.168.0.1
This field displays the IP Subnet Mask being used by the Local (LAN)
port of the gateway. The default is 255.255.255.0
If set to None, the gateway will not assign IP addresses to local PCs on
the LAN.
If set to Server, the gateway is configured to assign IP addresses to local
PCs on the LAN.
These parameters apply to the ADSL modem section of the gateway.
This field displays the ADSL chipset firmware version.
This field displays the state of the ADSL connection to your service
provider, either "Connecting" or "Connected"
This field displays the protocol used to connect to your service provider.
When the ADSL link comes up, the connection will be either "Fast" or
"Interleaved", depending on the way the telephone company has
configured its equipment
This field displays the connection rate from the service provider to the
gateway in bits per second
This field displays the connection rate from the gateway to the service
provider in bits per second
This field displays the VPI entered in the Setup Wizard or Basic Settings
screen
This field displays the VCI entered in the Setup Wizard or Basic Settings
screen
6-3