Power Connector; Mode Selector Switch; Input Connectors - US Blaster USB 7124 Owner's Manual

USB 7124 - 7125 - 7126
Professional Power Amplifiers
Rear panel

7. POWER CONNECTOR

The cord connector is used to connect an AC power source to your power amplifier.
(CAUTION : Always operate the unit with the AC ground wire connected to the electrical system
ground)
8. FUSE
Fuse holders for 5A-1OA / 250V fuses. If these fuses continuously blow, shut off the unit and have it
serviced by qualified service personnel.

9. MODE SELECTOR SWITCH

These US Blaster amplifiers offer 2 modes of operation: STEREO & BRIDGED.

10. INPUT CONNECTORS

Connect your input signal to these unballanced 1/4" TRS input jacks.
11. L/R CHANNEL OUTPUT CONNECTORS Connect to your speaker box
12.FAN
The fan speed is varied continuously and automatically to maintain the proper internal operating tem-
perature.
© US Blaster Europe BV
USB 7126
USB 7126