Page 1
Instruction Manual Manual to to to to Instruction Manual Instruction Instruction Manual BS14 Model WoodCutting Band Saw Please read manual before using using it it it it Please read manual before using Please Please read read the the manual manual before...
―Not-skid footwear is recommended. ―Wear restrictive hair covering to contain long hair. ―Use eye and ear protection. Always wear: ANSI approved dust mask or respirator when working around metal wood ,and chemical dusts and mists. A full face shield if you are producing metal or wood filings. Ear protectors ―Maintain proper footing and balance at all times.
Page 4
NOTICE: WE SUPPLY YOU INTERLOCK SWITCHES ONLY WHEN YOU PLACE AN ORDER. 5. 5. 5. 5. TABLE'S TABLE'S TABLE'S TINSTALLING TINSTALLING ADJUDTING ADJUDTING TABLE'STINSTALLING TINSTALLINGAND AND ADJUDTING ADJUDTING 5.1 INSTALLINGTABLE see Fig.(1) Install worktable (#83) according to Fig.(1). Fix the saw mouth (#85) into the center of worktable. Connect the guide board (#87) with the table use four butterfly screw bolts as Fig.(1).
6. 6. 6. 6. MANUAL MANUAL MANUAL BLADE BLADE MANUAL TO TO SAW SAW BLADE BLADE 6.1 TO CHANGE SAW BLADE MAKE SURE SWITCH IN “OFF” POSITION. AND UNPLUG THE SANDER BEFORE PERFORMING ANY OF THE STEPS BELOW. 1) First open the upper door and lower door (#8) &(#9), then loosen hand wheel (#20). Fig.(3) 2) Remove side guide board (#87) and saw blade (#36).
Page 6
7. 7. 7. 7. BREAKDOWN BREAKDOWN METHODS FIXING BREAKDOMN BREAKDOWN BREAKDOWN AND AND THE THE METHODS METHODS METHODS OF OF FIXING FIXING FIXING BREAKDOMN BREAKDOMN BREAKDOMN Items Reason Fixing Method 1. The motor can not 1. The power isn't on. 1.
Page 7
BS14 STAND PARTS NAME Q’TY Support parts Hex nut M8 Washer ø8 Carriage bolt M8×16 Connected plate (1) Connected plate (2) Rubber washer Hex bolt M8×40...
Page 8
Description Description Q'TY Q'TY Description Description Q'TY Q'TY Description Description Q'TY Q'TY Description Description Q'TY Q'TY Column cover Hexagon nut M16 Sawing body Motor wheel Copper washer Washer ø14 Magnetic switch Double-ended screw Hexagon head screw M8×20 Big triangle frame Motor Rubber belt for saw wheel Dust cover...
Page 9
Description Q'TY Description Q'TY Description Description Description Q'TY Q'TY Q'TY Description Description Description Q'TY Q'TY Q'TY Low wheel axle Guide board worktable Hexagon screw M6×20 insert Bearing pole Board of saw mouth Guide frame stand Large washer ø6 Single hole press board Side guide board Hexagon screw M6×12 Rotating angle rule...