Tape Recording - Harman Kardon AVR55 120 volt Owner's Manual

• To automatically scan through the
stations entered in the preset memory,
.
press the button v
P Scan
remote. The tuner will run through the
list of preset stations, stopping for five
seconds at each one. Press the
button again to stop the scan at your
desired station.

Tape Recording

In normal operation, the audio or video
source selected for listening through the
AVR55 is sent to the record outputs.
This means that any program you are
watching or listening to may be recorded
simply by placing machines connected
to the outputs for or
Tape 1
‚ •
in the record mode.
When a tape recorder with separate
record and playback heads is used, you
may monitor the output of the recording
by selecting the
Tape 1/Monitor
! d
. Note that the
T MON
•
K will illuminate in the front panel dis-
play to remind you that you are listening
to the record playback instead of the
actual input source being recorded.
Video Recording
The AVR55 permits you to make a video
recording from one of the input sources
while another source is being listened to
through the unit's main amplifiers.
AVR55 120 volt Rev (c) 10/1/97
Operation
To make a video recording, press the
Video 1 Record
on the observe the indicator dot at the far left
side of the front panel
. As you press the
Display 3 5
.
button, the
P Scan Video 1 Record
A will change to show which output is
being sent to the
The output may be either the current
listening source, or one of the other video
inputs (TV, DVD, Video 2).
IMPORTANT NOTE: Please make cer-
tain that you are aware of the copyright
restrictions on any material you copy.
Unauthorized duplication of copyrighted
materials is prohibited by Federal law.
Tape 2
Output Level Trim Adjustment
Normal output level adjustment for the
AVR55 is established using the Test Tone,
as outlined on page 19. In some cases,
input however, it may be desirable to adjust the
indicator output levels using program material
such as a test disc, or a selection you are
familiar with.
To adjust the output levels using pro-
gram material, first set the reference
volume for the front left/right channels
using the Volume Control ˘ n
you wish to vary the difference between
the left and right channels, use the
Balance Control Ù
To change the level for the channels you
wish to adjust use the appropriate front
panel level adjust control for the
,
Subwoofer
channels ¸ ˝ 3 4
26
button & and
Information
Record
indicator
jacks › .
Video 1 Out
. If
.
or
Center Surround
.
Memory Backup
This product is equipped with a memory
backup system that preserves tuner pre-
sets and system configuration informa-
tion if the unit is accidentally unplugged
or subject to a power outage. This mem-
ory will last for approximately one week,
after which time all information must be
re-entered.
Processor Reset
In the rare case where the unit's opera-
tion or the displays seem abnormal, the
cause may involve the erratic operation of
the system's memory or microprocessor.
To correct this problem, first unplug the
unit from the AC wall outlet and wait at
least three minutes. After the pause,
reconnect the AC power cord and check
the unit's operation. If the system still
malfunctions, a system reset may clear
the problem.
If the system is still operating incorrectly,
there may have been an electrostatic
discharge or severe AC line interference
that has corrupted the memory or
microprocessor.
If a reset does not solve the problem,
consult an authorized Harman Kardon
service depot.