Oven And Accessories / Installation; Installation Instructions - Sharp R-42B User Manual

6
1
4
5 3
11
13
14. Turntable
(glass)
16. Coupling
1. Remove all packing materials from the oven cavity, (do not remove the waveguide cover), and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned
door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any
damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY
SHARP and repaired, if necessary.
2. Accessories provided
1) Turntable 2) Turntable support
3) Coupling 4) Operation manual
3. Ensure t hat the coupling is installed.Place the turntable support on the oven floor, then place the
turntable onto the turntable support and coupling, ensuring it is located firmly. Refer to the diagram
ab ve o . NEVER operate the oven without the turtable.
4. This oven is designed for countertop or cabinet use as well. It should not be installed in any area where
excessive heat and steam are generated, for example, next to a conventional oven unit. The oven
should be installed so as not to block ventilation openings. Allow a space of at least 10 cm on the top,
5 cm on both sides and at the rear of the oven for adequate air circulation.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an
emergency.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
6. This appliance must be earthed.
7. Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
2 OVEN
10
1.
2.
3.
4.
9
5.
6.
7.
8.
8
7 4
9.
12 10. Waveguide cover (DO NOT REMOVE)
11. Power supply cord
12. Ventilation openings
13. Outer cabinet
ACCESSORIES:
Check to make sure the following accessories are
provided:
(14) Turntable (15) Turntable support (16) Coupling
• Place the coupling into the turntable motor shaft and then place
• To avoid turntable damage, ensure dishes and containers are
NOTE: When you order accessories, please mention two items: part
name and model name to your dealer or SHARP authorised service
agent.
15. Turntable
support
O V E N
Door handle
Oven lamp
Door hinges
Door safety latches
Door
Door seals and sealing surfaces
Turntable motor shaft
Oven cavity
Control panel
the turntable support in the centre of the oven floor so that it can
freely rotate around the coupling. Place the turntable onto the
turntable support so that it locates firmly into the coupling.
lifted clear of the turntable rim when removing them from the
oven.

INSTALLATION INSTRUCTIONS

3
A N D A C C E S S O R E I S