How To Install The Range Extender - Linksys RE1000 User Manual

Linksys Wireless-N Range Extender
Top
Power Switch
Featured only in the European versions of the extender.
Reset
Press and hold this button for about five seconds to reset the
extender to its factory defaults. You can also restore the defaults from
the Administration > Factory Defaults screen in the extender's browser-
based utility.
Wi-Fi Protected Setup Button
devices, such as wireless printers, that support Wi-Fi Protected Setup,
then you can use Wi-Fi Protected Setup to automatically configure
wireless security for your wireless network. To use Wi-Fi Protected Setup,
refer to "Using Wi-Fi Protected Setup" on page 7.
Bottom
Ethernet (green) Using Ethernet cables (also called network
cables), this Ethernet port connects Ethernet network devices
to your wireless network.
The green light turns on when an Ethernet device is connected
and active on this port. The light flashes when the extender is
sending or receiving data over the Ethernet port.
After initial setup, if you have client

How to install the range extender

1. Insert the Setup CD into a computer that is connected to the network
router. You will need to be near the router or access point and have
access to a networked computer.
IMPORTANT
Set up the extender close to the computer and router to ensure a
strong wireless signal. You can move it to a different location later.
2. When the Setup utility starts, read the license terms, then click Next. You
are prompted to plug your extender into an electrical outlet.
3. Connect your extender to an AC power outlet. Your extender searches for
wireless networks. The list of networks is displayed.
Contents
2