Sony RDP-NWR100 Operating Instructions Manual page 7

Opening the unit cover
1
Unfasten the buckles.
Push the arrowed parts as illustrated and
unfasten the buckles.
2
Open the unit cover.
Connecting a "WALKMAN" to
the unit
1
Connect the WM-PORT plug to the
"WALKMAN. "
Pull out the WM-PORT plug and insert it up

to the edge of the "WALKMAN" securely.
Connect the "WALKMAN" after disabling

its HOLD function.
Connect the "WALKMAN" after setting

the [SP Output Optimizer] to [Off] on
your "WALKMAN. "
For information on how to operate, refer
to the instructions supplied with your
"WALKMAN. "
Note
Remove the accessory case or strap from the

"WALKMAN" if attached.
2
Close the unit cover and fasten the
buckles.
Place the unit on a flat surface. Holding
the unit cover with one hand, fasten the
buckles with the other hand until they
click.
Before bringing the unit to the
bathroom, shower room, etc.
Check that two buckles are fastened securely.

Check that the "WALKMAN" is installed in the

unit.
7
GB