NEC NP1000 Network Setup Manual page 27

I Setting Wired LAN
1
Display the "Built-in" page of "LAN Mode".
Configure the setting of wired LAN in the "Built-in" page of "LAN Mode" selected from On-Screen
Menu. If "LAN Mode" is not displayed, refer to "5-1. Displaying On-Screen Menu (LAN Mode)"
( page 13).
2
Select "Profiles".
"Profile 1" or "Profile 2" can be stored in the memory of the projector as the setting of LAN.
<1> Press the SELECT
button.
SELECT /
<2> Use the
3
Set "DHCP".
Follow the same procedure as in "5-2. Wireless LAN" (
4
Input "IP Address", "Subnet Mask", and "Gateway".
Follow the same procedure as in "5-2. Wireless LAN" (
5
Input "DNS Configuration".
Follow the same procedure as in "5-2. Wireless LAN" (
6
Reconnect the network.
<1> When all the above items have been input or set, use the
"Reconnect" and press the
7
Finalize the setting.
<1> Use the button to highlight [OK] and press the
The setting will be stored in the memory of the projector.
button once to highlight the "Profiles" field and press the
button to highlight "Profile 1" or "Profile 2", and press the
button.
5. Setting the LAN Setting of Projector
page 17).
page 17,18).
page 18).
SELECT /
button.
button.
5
button to highlight
25