Panasonic HC-WX970HC-V770M Basic Operating Instructions Manual page 4

If the operating time is very short even after
the battery has been recharged, the battery
has worn out. Please purchase a new
battery.
About the SD card
≥ When the card access lamp is lit, do not:
j Remove the SD card
j Turn the unit off
j Insert and remove the USB cable
j Expose the unit to vibrations or shock
∫ About the recording format for
recording motion pictures
≥ Motion pictures recorded with other
devices are not supported by this unit.
series/
WX970 VX870
You can select from AVCHD
*2 *2
MP4 or iFrame recording formats to record
motion pictures using this unit.
series/
V770 V760
You can select from AVCHD
*2
iFrame recording formats to record motion
pictures using this unit.
*1 It is compatible with the AVCHD
Progressive (1080/50p).
*2 It is not compatible with motion pictures
recorded in AVCHD format.
AVCHD:
It is suitable for viewing on a high-definition TV
*3
or for saving to disc
*3 The following methods are available for
saving an image recorded in 1080/50p:
j Copy the image to a disc using the
HD Writer AE 5.2.
j Copy the image to a Panasonic Blu-ray
disc recorder that supports AVCHD
Progressive.
4
SQT0661 (ENG)
series
*1 *2
, 4K MP4 ,
*1 *2
, MP4 or
.
series/
WX970 VX870
4K MP4:
This is a recording format suitable for editing
images.
This format can record 4K motion pictures
(3840k2160/25p), which deliver a resolution
four times higher than that of full high-definition
motion pictures.
MP4:
This is a recording format suitable for playing
back or editing on a PC.
iFrame:
This is a recording format suitable for playing
back or editing on a Mac (iMovie etc.).
∫ Indemnity about recorded
content
Panasonic does not accept any responsibility
for damages directly or indirectly due to any
type of problems that result in loss of recording
or edited content, and does not guarantee any
content if recording or editing does not work
properly. Likewise, the above also applies in a
case where any type of repair is made to the
unit (including any other non-built-in memory
related component).
∫ About Condensation (When
the lens or the LCD monitor is
fogged up)
Condensation occurs when there is a change in
temperature or humidity, such as when the unit
is taken from outside or a cold room to a warm
room. Please be careful, as it may cause the
lens or LCD monitor to become soiled, moldy,
or damaged.
When taking the unit to a place which has a
different temperature, if the unit is accustomed
to the room temperature of the destination for
about one hour, condensation can be
prevented. (When the difference in temperature
is severe, place the unit in a plastic bag or the
like, remove air from the bag, and seal the bag.)
When condensation has occurred, remove the
battery and/or the AC adapter and leave the
unit like that for about one hour. When the unit
becomes accustomed to the surrounding
temperature, fogginess will disappear naturally.
series