Sharp LC-32GA6E Service Manual page 25

www.ma163.com 电子技术资料网
FREQ: Change between 50/60Hz and PC.
CLR MODE: When press OK key send the value to monitor microcontroller.
PATTERN1: Choose pattern to adjust QS.
PATTERN2: Choose pattern to adjust QS.
COMBIAS: Specifi c adjustment for QS. COMMON BIAS adjusting value is displayed.
IC CONT: See the next OSD.
SOFT VER.: Software version of QS IC. Display the version of monitor microcontroller.
COMBIAS Adjustment
Select COMBIAS and press the "OK" button so that the fl icker screen will appear.
Adjust the fl icker on the screen to minimum with up / down buttons on the remote control. At this time, press the "OK"
key to complete the adjustment.
IC Cont Menu (NOT OPERATIVE)
Send specifi c data to the QS board.
IC CONT
DEVICE
ADDR
DATA
R/W
SEND
GA6 VX.XX ExpX
PxW Exp X.X LCD VXX
DEVICE: To select QS peripherals ICs. ( 0:LCD Controller / 1:QS Driver / 2: Extended Digital Analog Converter /
3: EEprom Microcontroller / 4: Reserved)
ADDR: Address of register.
DATA: Read mode: Display data after executing "SEND" / Write mode: Select data to write.
R/W: Select Read or Write. ON: write
SEND: Send data to QS.
NVM Menu
To change NVM values.
MENU NVM
ADDR:
VAL :
SAVE
HDMI NVM WP
ERASE
A B C D E F
M T
GA6 VX.XX ExpX
PxW Exp X.X LCD VXX
ADDR: NVM address.
VAL: NVM Value.
SAVE: Save NVM changes.
HDMI NVM WP: Unprotect the EDID, that contains the recognizable formats of screen for HDMI.
ERASE: If you select YES and Turn OFF-ON the TV by main switch, the data of NVM will be recorded
to the default values .
In ADDR option of this menu, by using the colour buttons of R/C is possible to pass directly to A, B, C or D param-
eter.
Note: DO NOT change any NVM data, unless you have been advised to do by a Sharp representative. If data is
incorrectly changed, serious damage may occur to the receiver.
0
000
00
OFF/ON
OFF: read.
_ _ _ _
_ _
YES
NO
25
Use the up / down arrows to select a term in the
menu.
Confi rm the selection with OK.
Use the up / down arrows to change values.
Use the left / right arrows to change between pa-
rameters.
Press END button to return to the previous menu.
Use the up / down arrows to select a term in the
menu.
Confi rm the selection with OK.
Use the left / right arrows to change between pa-
rameters.
Use the up / down arrows to change values.
Press END button to return to the previous menu.
LC-26GA6E/LC-26BV6E
LC-26GA5E
LC-32GA6E/LC-32BV6E
LC-32GA5E
LC-37GA6E