Medisana WL 450 Manual page 16

GB
3 Operation
3.4
Light
settings
(L-Mode)
3.5
Activate an
alarm
3.6
Short time
alarm
3.7
Demo /
Snooze /
Quick Check
10
By pressing the L-Mode-button
the icon appears on the display and the level (0 - 20) of brightness.
The level of brightness increases in increments from 0 to 20. Press the
 
buttons or to adjust the brightness as desired.
If you press the L-Mode-button
gradually from setting number to 0, and the
reading, we recommend brightness level 20. Subsequently, the relax
mode is activated, in which the colour of light changes about every 8
seconds in this sequence: Red - blue - green - red/blue - blue/green -
green/red - red/blue/green. Press the buttons
brightness as desired.
If you press the L-Mode-button
be switched off.
With the Alarm-button
on the rate of keystrokes, AL1 (for alarm1) and/or AL 2(for alarm 2) are
displayed and are activated therewith. With the fourth press on the Al-

arm-button all alarms will be deactivated.
In the last 30 minutes before an activated alarm starts, the brightness
slowly adjusts to the brightness set for the alarm time. The volume selec-
ted for the alarm time, increases from the start of the alarm (when the
alarm time is reached) to the set value within 60 seconds. The regular
alarm is only activated, if there are more than 30 minutes between the
time when the alarm is set and the time at which the alarm is supposed to
be triggered. If there is less than 30 minutes between the time when the
alarm is set and the time at which the alarm is supposed to be triggered,
the alarm function will start 60 seconds before the setting time.
Pressing the Off button
kept for the next day. The alarm automatically switches off after 30 minu-
tes.
With the Zizz-button
short break). Pressing the button once sets an alarm to begin after 15
minutes. Each further press of the button extends the alarm time by 15
minutes (until max. 90 minutes). It starts the countdown to the desired
alarm time once the icon stops flashing.
Pressing the Off button
switches off after 30 minutes.
With the Demo / Snooze / Quick Check-button
ent functions depending on the current state of the device settings:
1. In case of deactivated alarm:
Demonstration function for all light and sound effects. The entire demo
process takes about 1 minute.
2. In case of set / activated alarm function:
Quick-Check function to check the settings of the alarm function. After dis-
play of all values, the Quick-Check function will be closed automatically.
3. In case of activated and effected alarm:
Snooze funcion. When the button is pressed within 30 minutes before
the set alarm time, the wake up function (including light and sound) will
stop until the setting time.

you activate the luminous element

a second time, the light darks down

a third time, all light functions will

you activate alarm1 and/or alarm 2. Depending

switches off the alarm - the settings will be

you can set a short time alarm (e.g. for taking a

switches off the alarm. The alarm automatically
icon disappears. For
 
or to adjust the

you can select differ-

,
G
G
G
G
G
G
G
G