Summary of Contents for Voyager 1450g2DHR
-
Page 1: Quick Start Guide
Voyager™ 1450g2DHR Corded Area-Imaging Scanner Quick Start Guide Перейти на русскоязычный сайт www.honeywellaidc.com. Rev A 10/15... -
Page 2: Getting Started
Note: Refer to your User’s Guide for information about cleaning your device. Getting Started Turn off computer’s power before connecting the scanner, then power up the computer once the scanner is fully connected. Power Supply Assembly (if included) - Page 3 Connecting the Scanner USB: Keyboard Wedge:...
- Page 4 RS232 Serial Port: RS485:...
-
Page 5: Reading Techniques
Reading Techniques The view finder projects an aiming beam that should be centered over the bar code, but it can be positioned in any direction for a good read. Hold the scanner over the bar code, press the button, and center the aiming beam on the bar code. - Page 6 COM Port number. Apple® Macintosh computers recognize the scanner as a USB CDC class device and automatically use a class driver. USB Serial USB PC Scan the following code to program the scanner for a USB PC Key- board with an Enter suffix. USB PC RS485 Interface The RS485 interface defaults to port 5B.
-
Page 7: Keyboard Country
Keyboard Country If your interface is USB Keyboard or Keyboard Wedge, your key- board layout default is a US keyboard. To change this layout, refer to the chart below for your keyboard country. Scan the Program Keyboard Country bar code below, then scan the numeric bar code(s) for the appropriate Country Code from page 2, then scan... -
Page 8: Turbo Mode
Turbo Mode This selection is a keyboard modifier, so it may only be used when your interface is USB Keyboard or Keyboard Wedge. The scanner sends characters to a terminal faster using Turbo Mode. If the termi- nal drops characters, do not use Turbo Mode. Turbo Mode On Turbo Mode Off Trigger... -
Page 9: Add Code Id Prefix To All Symbologies
Suffix If you want a carriage return after the bar code, scan the Add CR Suffix bar code. To add a tab after the bar code, scan the Add Tab Suffix bar code. Otherwise, scan the Remove Suffix bar code to remove the suffixes. -
Page 10: Function Code Transmit
Function Code Transmit When this selection is enabled and function codes are contained within the scanned data, the scanner transmits the function code to the terminal. Charts of these function codes are provided in your User’s Guide. When the scanner is in keyboard wedge mode, the scan code is converted to a key code before it is transmitted. -
Page 11: Data Format Editor Instructions
Data Format Editor Instructions The following are abbreviated instructions for entering a data format. For complete instructions refer to your User’s Guide, available at our website, www.honeywellaidc.com. 1. Scan the Enter Data Format symbol. 2. Primary/Alternate Format: scan 0 for Primary Format 3. -
Page 12: Programming Chart
Programming Chart... - Page 13 Save...
-
Page 14: Technical Assistance
EZConfig-Scanning To access additional features for the scanner use EZConfig-Scanning, an online configuration software tool, available from our website at www.honey- wellaidc.com. Technical Assistance Contact information for technical support, product service, and repair can be found at www.honeywellaidc.com. Limited Warranty For warranty information, go to www.honeywellaidc.com and select... - Page 15 This document contains proprietary information that is protected by copy- right. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written con- sent of HII. 2015 Honeywell International Inc. All rights reserved. Web Address: www.honeywellaidc.com...