Page 1 APPLICATION 1-2. 2. OPERATION PANEL TYPE 2-1. SPECIFICATION 2-2. EXPLANATION OF EACH OTHER 2-3. SELF-TEST 2-4. DUMP MODE SE7300 SD 3. CONNECTIONS SE7300 PD 3-1. SERIAL INTERFACE 3-2. PARRALL INTERFACE SE7300 ST 3-3 THE OTHERS SE7300 PT 4. OUTER APPEARANCE...
Page 2 2. OPERATION 1.OUTLINE 2-1. SPECIFICATION ITEM SPECIFICATION These printers are thermal method can be equipped in rack and stand alone on DESIGN PANEL TYPE desk. for various data communication, POS terminal and various system. PRINT METHOD DOT Matrx MACHANISM Prior to actual use, please read this instruction manual carefully for your correct COLUMNS 24/30/40 ON ENGLISH understanding.
Page 3 3. CONNECTIONS 2-2. EXPLANATION EACH OTHER FUNCTION OF SE7300 ITEM FUNCTION 3-1. Serial interface RED LED POWER INDICATOR. Serial(RS-232C) POWER ON, WHEN LIGHTING LAMP. Data Transmission RS-232C Asynchronous GREEN LED INDICATOR “ON-LINE” Handshaking DTR/DSR or XON/XOFF control l ON LINE (STANDBY PRINTING.) Signal Level MARK = -3 ~ -15V : “1”...
Page 4 3-2. Parallel interface 2 TXD 1) Parallel 3 RXD Data Transmission 8-bit parallel Handshaking STROBE and BUSY or ACK 6 DSR Connector D-SUB 25 MALE 7 GND Interface Connection 20 DTR STROBE 9 Pin D-SUB Connector (FEMALE) 25 Pin D-SUB Connector HOST (MALE) ↕...
Page 5 Interface Connector and function Signal Timing Chart SIGNAL DIR. FUNCTION /STROBE l STROBE Pulse is occurred on reading data. l HIGH on normal , LOW on reading data DATA0 DATA1 BUSY l Parallel data bits DATA2 /ACK “1”on HIGH, “0”on LOW. DATA3 DATA4 DATA5...
Page 6 4. OUTER APPARANCE 3-3. THE OTHERS S/W CONNECTOR SE7300 4-1. SE7300 SW No. Define Serial Baud Rate 9600 bps 192000bps 115200bps 2400bps HanGul Type WANSUNG JOHAP Control Command EPSON INTERNAL Columns 30Columns 40Columns 24Columns 24Columns Parity None Parity Odd Parity Even Parity * Default mode on factory - out POWER CONNECTOR...

This manual is also suitable for:

Se7300 pdSe7300 stSe7300 pt