Audio Pro ace-bass Avanti A.100 Instruction Manual page 7

INSTRUCTIONS
Congratulations to your choise of Audio Pro Avanti A.100 and to a new sound experience.
Audio Pro Avanti A.100 is a unique product built with advanced technology. It is very easy to
handle and install. Avanti A.100 is equipped with the unique Audio Pro ace-bass technique that in
combination with the built-in 175 watts amplifier, the long throw 8" woofer and the extremely solid
cabinet offers a natural and deep bass reproduction at sound levels you never thought existed.
The Audio Pro Avanti A.100 offers extraordinary performance and lots of possibilities. In order to
get the most out of your new loudspeaker, we recommend you to spend time and carefully read
these instructions before you connect and start up your system.
What is ace-bass ?
Normally, speaker design is bound to follow the laws of physics. The consequence will be, to
get deep bass, the speakerbox must be very large. With the ace-bass technique we can "change"
the laws of physics in the way that the driver believes it is placed in a much larger speaker box.
Furthermore, the ace-bass technology improves the driver performance. With the ace-bass
technique, we can design smaller subwoofers with deeper and cleaner bass.
1. UNPACKING
Carefully unpack the Audio Pro Avanti A.100 and check
for any damages. If possible, keep the cartonbox if future
transportation would be needed. Locate the enclosed
accessories: 1 x RCA cord and 1 x Y-adaptor.
You should immediately contact your dealer if the spea-
ker is damaged .
2. CONNECTION
TWO CHANNEL ( Stereo).
Connect a good quality speakerwire between your amplifier
speaker output to HI LEVEL IN on the speaker amplifier.
Check carefully the phase (+ to +) and (- to-).
Caution: Do not connect the mains cord until all other
connections are completed.
Note: The signal is passed through the subwoofer amplifier
to the top crossover network. Adjust the subwoofer level
to match the upper speakers by using the Master level
control (2).
MULTICHANNEL (5.1 surround)
Connect your speaker as above (for two channel). In
addition connect the RCA cord from SUB-OUT on your
5.1 amplifier to LINE-IN on the speaker amplifier. Use the
Y-adaptor to connect both Left and Right subwoofer.
Caution: Do not connect the mains cord until all other
connections are completed.
Note: The speaker is working in the same way as for the
two channel connection (above). However, the separate
subwoofer channel (5.1) is also handled by the subwoofer.
Use the LINE-IN LEVEL to adjust the 5.1 subwoofer level
(1).
7