Download Print this page

Kenwood CAW-KIMUN1 Installation Manual page 4

Steering wheel remote control

Advertisement

Parking Distance Control
In case of no OEM Parking sensors, the OSD information will NOT be displayed
In case of "Climatic Control" (manual A/C) the OSD information will NOT be displayed
Depending on vehicle specifications the OPS (Optical Parking System) needs to be activated
Before you start the re- installation please take care of the following:
IF YOU NEED TO INSTALL THE SAME IN A NEW CAR (EVEN IF IN A SAME GROUP MODEL)
1.
WITH THE UNIT POWERED ON, PRESS THE "CAW-KIMUN1" BUTTON UNTILL THE
LED SWITCHES OFF
2.
WHEN THE LED SWITCHES OFF, RELEASE THE BUTTON. THE RESET IS DONE
it's necessary to de-activate the MFD functions on the KIM interface. To do so please follow
below steps:
1) Disconnect the KIM interface from the power, then set DIP switch 3 to "ON"
2) Connect the KIM interface with power.
3) The LED will flash: 1x orange, followed by red flashes
4) Press 6 times on the button in the KIM interface and verify the LED flashes:
7x orange and 1x red.
5) Push for long time the button in the KIM interface until the LED switches OFF.
6) Now release the button and verify that the LED flashes 7x orange and 2x red.
7) Once verified above point 6, disconnect the KIM interface from the power
8) Set DIP switch 3 to "OFF" and re-connect the interface with power.
4
AVAILABLE OSD IMAGES
The availability of OSD images depends on the vehicle attributes
IT IS NECESSARY TO RESET THE MODULE
ATTENTION! If the vehicle is equipped with:
a) MFD display which is not showing the Body computer or
b) equipped with a MFD PLUS without Steering wheel controls.
Climatronic Control Information
Note:
RE-INSTALLATION
RESET:
LED
KIM
BUTTON

Advertisement

loading