Haier HMS1000TVE Servise Manual page 20

Error message. Motor overheat protection or is damaged.
Troubleshooting:
Cut off power and check if motor wires
are connected well
Y
Measure if resistance of motor winding by
multimeter, is it as followed? 1-2:5 ;
3-5:5 ; 7-8 :5
Y
Pull out the wire connection of motor
Then check if circuit is open by multimeter
Front Load Washing
Repair wires
Y
Page 19
Reconnect well
N
Put the motor in normal temperature about
ten minutes, and then test again. If the
N
resistance is natural, it is caused by
overheated protection. Then check and
deal with overload, abnormal voltage. If
not, please replace motor