Miele CarClean Set Plus Operating Instructions Manual page 65

S 5980 / S 5981
^ Connect the CarClean Set hose.
^ Turn the vacuum on with the
On/Off s foot switch.
^ Press the reset button.
The vacuum turns on but can only be
operated with the maximum suction
power.
Hose holder
To store the suction hose, the suction
hose holder, e, can be mounted on the
wall (illustration n).
Using the Hand Turbobrush o
The Hand Turbobrush is suitable for car
care. It can be used to vacuum car se-
ats, floor mats and carpets.
Maintenance and care
,
Always disconnect the vacuum
cleaner from the electrical supply
before performing cleaning or main-
tenance work on the Hand Turbo-
brush. Turn the vacuum off and un-
plug it.
Removing threads and hairs (Illustra-
tion p)
^ Cut any threads or hairs that have
become entangled on the brush roller
with a pair of scissors. The cut pieces
will be drawn in by the suction power
of the vacuum cleaner the next time it
is used.
More stubborn tangles or blockages
can be removed after opening the roller
cover. Any large particles which have
been drawn in can then be removed.
^ Turn the neck of the Hand Turbobrush
so that the release button is in the
middle of the guide (illustration q - a).
^ Press the release button (illustration
q - b), and pull the neck from the
Turbobrush as far as it will go (illu-
stration q - c).
^ Lift the upper part of the casing as far
as it will go (iIlustration r), and re-
move any debris from the inside of
the casing and the brush roller.
^ Close the casing and push the neck
back into position until it clicks into
place over the release button.
en (US/CA)
65