Spirit CareSens N Voice Owner's Booklet page 16

Step 10
After the symbol appears on the screen, apply the blood
sample to the narrow end of the test strip. If the blood sample
does not fill the confirmation window completely, an Er4
message may appear because of abnormal viscosity or
insufficient volume. If the talking function is on, the meter will
say "Error four. The sample was not enough or too thick. "
Then discard the test strip, insert a new one, and apply the
blood sample again after
It is recommended that the application of blood sample to the
test strip be performed virtually vertical to the sample site as
shown in the diagram below.
Note: The meter may switch off, if the control solution is not
applied within 2 minutes of the
screen. If the meter turns off, remove the strip, reinsert, and
start from step 2.
28 www.i-sens.com
symbol appears on the screen.
Good Sample
Insufficient
Sample
symbol appearing on the
Step 11
The test result will appear after the meter
counts down from "5" to "1". If the talking
function is on, the result will be announced.
The result will be automatically stored in the
meter memory.
Step 12
Discard the used test strip safely in a
disposable container by pushing up
the test strip ejector. If the
test strip is removed after the test
result is displayed, the meter will
automatically turn off after 3 seconds.
www.spirit-healthcare.co.uk 29