Philips BDL5545E Service Manual page 32

Scan mode
Note: For HDMI-Video timing, DVI-D(HD timing), DP(HD timing) and
Change the display area of the image.
Press the SET/PLUS button to open the submenu, and then press the UP/DOWN button to toggle
between
Overscan - Display about 95% of the original size of the image. The rest of the areas surrounding
the image will be cut off.
Underscan - Display the image in its original size.
Scan conversion
Choose to enable or disable the IP (Interlace to Progressive) conversion function.
Press the SET/PLUS button to open the submenu, and then press the UP/DOWN button to toggle
between
Progressive - Enable the IP conversion function (recommended). Once enabled, the interlace
input signal will be converted to progressive format for better display quality.
Interlace: Disable the IP function. This mode is suitable for displaying motion pictures, but it
increases the chance of image retention.
Film mode
Choose to turn on or off the film mode frame conversion function.
Press the SET/PLUS button to open the submenu, and then press the UP/DOWN button to toggle
between
Auto - Enable the film mode frame conversion function for movies and motion pictures. The
display converts a 24 frames-per-second (24 fps) input signal format to DVD video signal format.
Once this function is enabled, it is recommended that you set the Scan conversion function to
Progressive.
Off - Disable the film mode frame conversion function. This mode is suitable for TV broadcasting
and VCR signals.
IR control
Select the operation mode of the remote control when multiple BDL5545E displays are connected via
an RS232C connection.
Press the SET/PLUS button to open the submenu, and then press the UP/DOWN button to toggle
between
Normal - All displays can be operated normally by the remote control.
Primary - Designate this display as the primary display for remote control operation. Only this
display can be operated by the remote control.
Secondary - Designate this display as the secondary display. This display can not be operated by
the remote control, and will only receive the control signal from the primary display via the RS232C
connection.
Lock - Lock the remote control function of this display. To unlock, press and hold the DISPLAY
button on the remote control for 5 seconds.
Component inputs only.
Philips BDL5545E 31