Recording Speed - Samsung MX-JS9000 User Manual

Functions
✎ You can not record audio from the radio
when searching for a station or if there are no
frequencies available when the product is set
to Tuner mode.
✎ Note that setting the input level too loud when
recording music from an external device
through the AUX or USB channel may introduce
noise into the recording. If this occurs, lower
the external device's volume level.
✎ The maximum TUNER/AUX recording time is 5
hours.
✎ If USB2 has no USB device connected, and
you press the USB REC button, "USB2 NOT
READY" is displayed.

Recording Speed

You can select the recording speed before
recording.
During the CDDA disc mode, each time you press
the REC SPEED button on the remote control,
the recording speed will change as follows:
NORMAL SPEED RECORD ; HIGH SPEED
RECORD
• When you record from the tuner or an external
source, you cannot change the recording
speed.
• If you select HIGH SPEED RECORD, sound is
not produced during the recording.
• If you connect the microphone, you have one
recording speed mode available: NORMAL
SPEED RECORD.
• During recording, if you disconnect the
microphone, the recording will stop. If you
reconnect the microphone, the recording will
not restart.
| NOTE |
✎ Even when HIGH SPEED RECORD is set,
recording may not be made in x4 speed
depending on the used USB storage device.
[MX-JS9000-SJ,ZN]AH68-02850E-00ENG.indd 24
Special Sound Effects
Selecting PRESET EQ Mode
Your Hi-Fi Component system provides predefined
equalizer settings that are optimized for particular
music genre.
1. Press the PRESET EQ button.
Each time you press the PRESET EQ button
repeatedly, or press the PRESET EQ button,
and then turn the VOLUME/SEARCH JOG
control on the product, the mode will change
as follows:
HIP HOP ; ROCK ; JAZZ ; CLASSIC ;
ELECTRONIC ; FLAT ; ARABIC MUSIC
; PERSIAN MUSIC ; GENGE ; BONGO
; RHUMBA ; ESKISTA ; AFROPOP1 ;
AFROPOP2 ; INDIAN POP ; PARTY ; POP
2.
After selecting the desired mode, Use the
adjusting JOG for each 80Hz, 200Hz, 800Hz,
2kHz and 8kHz levels to fine tune EQ.
3.
After adjusting your desired band among the
PRESET EQs, press the MEMORY button
to display the "SAVE TO USER EQ". The
adjusted EQ is then saved as USER EQ.
| NOTE |
✎ Preset EQ Default value is HIP HOP.
Selecting USER EQ Mode
USER EQ mode shows up to 5 equalizer bands
according to the user's setup.
1. To configure the EQ manually, press USER
EQ button. You can adjust levels manually.
2. Use the adjusting JOG for each 80Hz,
200Hz, 800Hz, 2kHz and 8kHz levels to fine
tune EQ.
| NOTES |
✎ When the Hi-Fi Component is recording, the
EQ function is turned off automatically and is
unavailable.
✎ If no buttons are pressed within 8 seconds,
your settings will automatically be cancelled
and the previous settings will be saved.
24
English
2015-03-23 오전 11:08:57