Trademark Declaration; Specific Absorption Rate Information - Philips CTI908BK User Manual

Note:
• Check with the local authorities whether or not you are allowed to
use the phone while driving.
Your phone is not charging
If the battery is completely flat, it might take several minutes of pre-
charge (up to 5 minutes in some cases) before the charging icon is
displayed on the screen.
The picture captured with the phone camera is not clear
Make sure that the camera lens on both sides is clean.

Trademark Declaration

Android Android is a trademark of Google, Inc.
Bluetooth™ Bluetooth™
telefonaktiebolaget L M Ericsson, Sweden and licensed
to Philips.
Philips PHILIPS and PHILIPS' Shield Emblem are registered
trademarks of Koninklijke Philips N.V. manufactured by
Shenzhen Sang Fei Consumer Communications Co.,
Ltd. Under license from Koninklijke Philips N.V..

Specific Absorption Rate Information

International standards
THIS MOBILE PHONE
RECOMMENDATIONS FOR EXPOSURE TO RADIO WAVES
Your mobile phone is a radio transmitter and receiver. It is designed and
manufactured not to exceed the limits for exposure to radio frequency
(RF) energy defined by
recommendations have been established by the International
Commission on Non-Ionizing Radiation Protection (ICNIRP) and, the
Institute of Electrical and Electronics Engineers (IEEE) that forecast a
is a trade-mark owned
MEETS THE INTERNATIONAL
the international standards.
substantial safety margin for assuring the protection of all persons,
regardless of age and health.
The exposure recommendations for mobile phones use a measurement
unit known as the Specific Absorption Rate (SAR). The SAR limit
recommended by the ICNIRP for the mobile phones used by the general
public is 2.0W/kg averaged over ten grams of tissue and, is 1.6W/kg
averaged over one gram of tissue by IEEE Std 1528 for the head.
Tests for SAR have been conducted using recommended operating
positions with the mobile phone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR levels of
the mobile phone while operating are generally below the maximum SAR
value. This is because the phone is designed to operate at multiple power
levels so as to use only the power required to reach the network. In
general, the closer you are to a base station antenna, the lower the
by
power output.
While there may be differences between the SAR levels of various
phones and at various positions, they all meet the international
protection standards for exposure to radio waves.
The highest SAR value for this I908 model phone when tested
for compliance against the standard was 0.534 W/kg for
ICNIRP recommendation.
For limiting the radio waves exposure, it is recommended to reduce the
mobile phone call duration or to use a headset. The purpose of those
precautions is to take the mobile phone away from the head and the
body.
These
Safety & Precaution 33