Page 1
Set-up Instructions WD90U/CN90U . Remove cardboard carton from metal frame 2. Remove operating instructions, manufacture statement of origin,and owners manual located on top of ATV. REV - A...
Removal from crate 4. Carefully remove metal frame 3. Remove bolts as indicated in photo from both sides of metal frame 5. Remove wire straps from front bumper 6. Remove wire straps from rear axle.
Handlebar Assembly 7. Loosen plastic guard bolt and remove plastic guard. 8. Loosen all bolts and lift handle bars to desired position, tighten handle bar bolt. Torque to 25Nm (8.5ft.lb). Replace the plastic guard and tighten bolt.
Page 4
Flag pole Assembly 9. Remove nut from flag holder assembly. Flag holder assembly Flag holder assembly Mounting bracket 0. Attach flag holder assembly to mounting bracket on rear rack of ATV and tighten nut. . Insert flag pole into flag holder assembly.
Battery Installation 2. Refer to battery section of owners manaul for correct installation and charging of battery. Battery is located under the seat...
Page 6
Gas and Oil 0. Fill engine with correct amount of oil. Refer to owners manual for oiltype and quantity. Gas Cap Oil Cap . Fill gas tank as specified in owners manual. !!WARNING!! 2. Refer to owners manual for proper starting instructions.