Ericsson HN290dp Quick Installation Manual page 7

- to the USB port - to the USB port - to the USB port - to the USB port - to the USB port
NOTE! NOTE!
NOTE! NOTE! NOTE! DO NOT connect the USB cable yet.
Insert the provided "Drivers & Documentation" CD and follow the
instructions given in step 4.
3 3 3 3 3 CONNECT THE POWER SUPPL CONNECT THE POWER SUPPLY Y Y Y Y CONNECT THE POWER SUPPL
CONNECT THE POWER SUPPL CONNECT THE POWER SUPPL
Connect the provided Power cable
your HN290dp and plug the power supply adapter into a power
source.
Start the HN290dp Start the HN290dp
Start the HN290dp Start the HN290dp by pressing the Power Start the HN290dp
of the HN290dp.
4 4 4 4 4 INST INST ALL USB DRIVERS ALL USB DRIVERS
INST INSTALL USB DRIVERS INST ALL USB DRIVERS ALL USB DRIVERS
NOTE! NOTE! NOTE! This should only be done if you have connected a computer
NOTE! NOTE!
via the USB interface, otherwise continue to step 5.
DO NOT connect the USB cable until you are instructed by the instal-
lation program.
For USB connection you need to install USB drivers to your PC.
Follow the instructions below to install USB drivers and connect the
HN290dp to the USB interface.
1 . 1 . 1 . 1 . 1 . Close ALL Windows applications and insert the provided "Drivers
& Documentation" CD into your CD-ROM drive.
2 . 2 . 2 . 2 . 2 . The CD starts automatically and the following window appears:
If Autostart fails, select Start > Run
(where D: is the letter of your CD-ROM drive) and press Enter.
Power cable Power cable to the POWER Power cable
Power cable
Power Power
Power button on the back Power
Start > Run Start > Run
Start > Run Start > Run, type D:\startup.exe
POWER socket on POWER POWER
POWER
D:\startup.exe D:\startup.exe
D:\startup.exe D:\startup.exe
Installation 7