Programming The; Status Led Reference - RTI XP-6 Installation And Operation Manual

It's Under Control
®
CHaPteR 3 | InstallatIOn and OPeRatIOn
PROGRammInG tHe XP-6
The XP-6 must be programmed to operate. All programming is done using
RTI's Integration Designer software and is downloaded using the USB
®
port.
After the Ethernet parameters are configured, system files can be
downloaded over Ethernet.
The software allows you to create actions (e.g. commands and macros)
that are associated with button presses on one or more RTI remote
controls. The software transparently creates all of the system trigger
codes, and generates the correct download for every device in the
system. Unless you implement some of the software's advanced features,
programming a system that uses a XP-6 is just as easy as programming
one that doesn't.
status led
The status LED will illuminate green and stay green if there is no
Integration Designer system file installed on the XP-6.
The status LED will illuminate red for a few seconds while the XP-6 is
loading the Integration Designer system file that is installed. Once finished
loading, the status LED will shut off.
The status LED will illuminate green if a valid system trigger code is
detected. The LED will stay on while the XP-6 is busy processing the action
associated with the trigger code.
The status LED will illuminate red and stay red to indicate if the XP-6 is in
firmware update mode. This process is described in the firmware update
wizard. If there is a firmware update available for the XP-6, it can be found
on the dealer section of the RTI website (www.rticorp.com/dealers).
settInG tHe ZOne COde
If the XP-6 is installed in close proximity to others, the system Zone Code
can be changed in the Integration Designer software. This allows up to
®
256 separate control systems to operate in the same general area such as
multi-dwelling units or homes with more than one media system.
7