Page 1
Titan Pro 1100B Assembly Instructions Tools Required for Assembly 16mm Spanner 16mm Socket 13mm Spanner Extension bar for socket 10mm Spanner Phillips screwdriver 8mm Spanner Grease for lubrication NOTE: THIS UNIT IS HEAVY SO TAKE CARE. 2 PEOPLE MAY BE REQUIRED TO ASSEMBLE THE FIRST PART 1.
Page 2
3. Lean Machine to the left and slide on right hand wheel 4. Insert Pin (shown below) into shaft as shown to secure wheel (Left) 5. Repeat on right hand side. A Handrail Stand B Bolts and brackets for fixing onto machine C Slide handrail stand under bracket D Bracket in position...
Page 3
7. Using 4 x 16mm bolts fix bracket into place. Use washer above and below bracket and spring washer underneath. 8. Remove adjustment bolt and lever (above left) and slide handlebars onto handrail stand. Replace bolt ensuring that the bolt goes into hexagonal hole (above middle). Tighten with lever to adjust to desired position.
Page 4
A Front mud guard mounting bracket (x2) B Fit bracket to mounts each side of engine using 2 x 13mm bolts and washers A Rear mud guard mounting bracket B Fit bracket to mounts using 16mm bolts and washers, fit loosely.
Page 5
16. Slide right hand outer tine cover under 3 bolts and tighten to secure in place. Repeat on left side. Tighten all bolts on tine cover, including those on the rear bracket, ensuring that they are all tight. 17. Place the rubber battery protector into the battery compartment.
Page 6
21. Place depth gauge into rear slot on machine. Adjust the pin for desired height. 22. Assembly of the tines. The tines are left and right handed and are marked as such. Picture shows one bar and tines required. Repeat this for the other tine bar and extension bar.
Page 7
23. Assembly of the unit is now complete. Grease the following cables as shown above A Drive cable B Clutch cable C Dead mans handle cable To fit the tines to the machine, remove the pins holding the wheels on. Remove the wheels, and slide on tines.
Page 8
Adjustment of Cables To adjust cables: Clutch Adjustment – Turn the nut on spindle below handle one full turn and retry machine. Deadman’s Handle Cable – Loosen bottom nut and tighten top nut half turn. Lubricants Engine Oil. - Using orange filler cap, fill Gearbox oil –...
Need help?
Do you have a question about the 1100B and is the answer not in the manual?
Questions and answers