Quick Start Guide For more information, visit www.caldigit.com...
Page 2
Fast, Reliable and Secure Storage Solutions Apple, Apple Logo, Mac, the Mac logo and Macintosh are trademarks of Apple Inc. Microsoft, Windows and Windows Logos are registered trademarks of the Microsoft Corporation. All other trademarks are the property of their respective owners. *Speci cations and package contents are subject to change without notice.
General Use Warnings Safety Warnings Package Contents Installing SuperShare Installing HDPro2 or HDPro-24 Storage Installing SuperShare Host Adapter Card Installing Optical Cable Installing PCIe Cable Power On Shutting Down Accessories and Parts Technical Support & Warranty Information Technical Support CalDigit Warranty Information...
Please read the SuperShare manual thoroughly and become familiar with the product before use. Only use the CalDigit SuperShare in an area with cool ventilation. Make sure that the fans are not obstructed to ensure heat dissipation. Do not leave or use the SuperShare near a heat source such as a heater or direct sunlight.
(Four) Optical Cable. (10M, 30M, 50M or 100M) (One) PCIe (8-lane) cable. (Four) SuperShare Host Adapter Card. (Two) Rack mounting kits. One for Switch, One for Hub. (One) CalDigit SuperShare CD (Two) Power supply kit. Please contact your CalDigit reseller for any faulty or missing parts.
Installing HDPro2 or HDPro-24 Storage Please refer to the HDPro2 or HDPro-24 installation procedure or manual. Manuals can be downloaded from www.caldigit.com/support.asp. Installing SuperShare Host Adapter Card Turn o your computer and unplug the AC power cord from the wall or power bar.
Page 7
Locate available PCIe slot on motherboard. Always put the PCI card in Slot #3 or Slot #4 to obtain optimal performance. Hold the PCIe card mrly by the ouside edge, push it into the slot making sure the PCI connectiins t outside the computer.
PCIe 8x Cable Installing RAIDShield and Driver to all workstations Insert the provided CD into the computer DVD/CD drive or visit www.caldigit.com/support.asp. Go to "Mac Installer" Folder or "Windows Installer" Folder. Launch SuperShare Installer. When installation is complete, shutdown the computers.
Power On To power on the SuperShare SAN, please follow the steps: Power on all HDPro2s or HDPro-24s. Wait 5 seconds. Power on SuperShare Hub. Wait 5 seconds. Power on SuperShare Switch. Wait for three beeps from the Switch, this may take up to 2 minutes. Power on all workstations.
If you run into any issues while installing SuperShare please contact CalDigit Technical Support: support@caldigit.com www.caldigit.com/support.asp 1-714-572-6668 When contacting CalDigit Technical Support, make sure to be at your computer and have the following information available: • Your CalDigit serial number • Operating system and version • Computer brand and model •...