1. OWNER’S MANUAL & SAFETY INSTRUCTIONS 1.1. How to read the manual. 1.1.1. Keep this manual for the safety warnings and precautions, assembly, operation, inspection, maintenance and cleaning procedures. 1.1.2. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number).
Page 4
2.2.3. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 2.2.4. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool.
2.4.7. Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions and the work to be performed. 2.4.8. Use of the power tool for operations different from those intended could result in a hazardous situation.
4. UNPACKING and ASSEMBLY TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Make sure that the Trigger is in the off-position and unplug the tool from its electrical outlet before performing any procedure in this section. This packaging contains sharp objects. Take care when unpacking. Remove the machine, together with the accessories supplied, from the packaging.
Page 7
4.2.6. Use a piece of wood to slide the new or reversed knife lengthwise into the knife rum, between the press blade plate and the knife holder. 4.2.7. Place a straight edge or straight piece of wood along the side surfaces of the front base plate and rear base plate.
4.6. Guide Adjustment 4.6.1. The guide can be used to adjust the width of cut, support the planer, and keep the planer from drifting away from the cut line (i.e., the edge of a door). 4.6.2. The guide may be attached either to the right side of the planer or on its left side.
Then, transfer pressure to the rear base plate, and continue planing slowly to the end of the cut. Do not pull the planer back over the surface already cut. 5.8. If necessary, repeat Step 5.7, using progressively deeper cuts until you near the desired depth. 5.9.
9.3. Email contact; Technical service@genpower.co.uk 9.4. Web site; www.hyundaipowerequipment.co.uk 10. DECLARATIONS OF CONFORMITY 10.1. Genpower Ltd confirms that this Hyundai product conform to the following CE Directives; 10.1.1. 2006/42/EC Machinery Directive 10.1.2. 2004/108/EC EMC Directive 10.1.3. 2006/95/EC Low Voltage Directive Page 10...