Citizen NIGHT ROLLERS II Instruction Manual

CITIZEN QUARTZ
NIGHT ROLLERS II
Model No. MC5XXX
Cal. No. D298
• Instruction Manual
CTZ-B6907
When reading this instruction manual please
keep the watch diagram above in view. Symbols
( . , etc) used in the sections on operating
A B
instructions refer to the symbols indicated in
this diagram.
Thank you for purchasing a CITIZEN QUARTZ
Watch. To ensure correct use, please read these
instructions carefully. Please confirm that the
CITIZEN International Guarantee Card is included
for your possible claim.
1. SWITCHING FUNCTION DISPLAYS
• This watch is equipped with six functions
consisting of time and calendar, alarms 1 and 2,
stopwatch, timer, dual time and chime (hour time).
2. SETTING THE TIME AND CALENDAR
1. Pressing and holding button
seconds digit to flash enabling the seconds to be
set.
2. Press button to reset the seconds.
A
• When the seconds displayed are from 30 seconds
to 59 seconds, pressing the button
the seconds digits to zero and advances the
minutes by 1.
3. Each time button
B
portion of the display will change as shown
below. Press button
display you want to correct flashes.
4. Press button to set the flashing digit of the
A
display.
• Pressing and holding button
the flashing digit to advance rapidly.
Pressing button
M
returns the watch to the time and calendar display.
If a button is not pressed for 1 minute in any of
the setting states, the watch will automatically
return to the time and calendar display.
3. USE OF ALARMS 1 AND 2
• The procedure for setting the alarm for alarm 1
and alarm 2 is exactly the same. Only the beeping
tone is different.
1. Press button
alarm 2. The alarm mark will flash.
2. Press and hold button
the "hour" digit flashes. The "hours"
can be set by pressing button
(holding button
display to advance rapidly).
3. When button is pressed, the flashing digit will
B
change from "hours" to "minutes". Set the
"minutes" with .
A
4. Pressing button
B
normal alarm state.
The alarm sounds for 20 seconds.
Pressing any of the buttons will turn the alarm
sound off.
When desiring that the alarm not sound at the
set time, press button
switch from the "alarm time display" to the "OFF
display".
When switching from the alarm OFF display to
the alarm ON display (alarm time display),
holding button in enables you to listen to the
A
alarm sound.
in for at least 2
B
returns
A
is pressed, the flashing
until the digit of the
B
in will cause
A
in any of the setting states
to select alarm 1 or
M
in until
B
in will cause the
A
returns the watch to the
while in alarm mode to
A
A