How To Replace The Motion Drive Belt - Murray 461000x8A Operating And Maintenance Instructions Manual

HOW TO REPLACE
THE MOTION DRIVE BELT
REMOVAL
1. Remove the mower housing. See the instructions on "How To
Remove The Mower Housing".
2. Completely push the pedal forward and engage the parking
brake.
3. Remove the idler pulleys (Figure 31).
Idler Pulley
4. To access the belt guides, remove the battery and battery tray.
See "How To Remove The Battery".
5. Loosen the belt guides at the drive pulley (Figure 32).
Seat Spring
Belt Guide
6. Remove the motion drive belt from the drive pulley
(Figure 31).
7. Remove the hair pin from the shift link (Figure 33). Pull the
motion drive belt over the shifter bracket.
F–030718L
MAINTENANCE
Idler Pulley
Motion
Drive Belt
Drive Pulley
Figure 31
Figure 32
Belt Guide
Shifter
Bracket
Hair
Pin
8. To remove the motion drive belt from the stack pulley, pull the
front end of the belt under the stack pulley and then back
between the stack pulley and the steering plate (Figure 34).
FRONT
Stack Pulley
Motion
Drive
Belt
9. Remove the access panel (Figure 35).
10. Remove the two screws that attach the steering shaft
assembly (Figure 35). Raise the steering wheel and steering
shaft assembly. Pull the motion drive belt under the steering
shaft assembly.
Screw
Steering Shaft
Assembly
Motion Drive
Belt
11. Remove the motion drive belt. A correct replacement part or
assistance is available from an Authorized Service Center in
your area.
30
Steering
Belt Guides
Access Panel
Shift Link
Figure 33
Plate
Figure 34
Figure 35