Battery And Charging; Installing The Battery; Charging The Battery; Battery Status - Techmade TECH SMART POCKET 280 Manual

Table of Contents

Advertisement

Battery and charging

Installing the battery

Only use quali fied battery and accessories. When the battery isn't used, put it in the protective case.
Note: Please operate according to the figure to avoid damaging the battery contact.

Charging the battery

The new battery will reach its optimized performance after complete charging and discharging for
several times.
Please charge in time when the battery voltage is low. Over discharging will damage the battery.
Disconnect the charger from the AC power supply and the mobile phone after charging. While
charging, the battery status icon flashes from right to left, and stops flashing after charging. It is
normal that the battery becomes warm in the charging process.

Battery status

Your mobile phone can monitor and display the battery status.
1> You can check the battery status from the icon in the upper right corner of the screen.
2> If the electricity is insuf ficient, the "Low Battery" prompt shows up. The mobile phone sends
warning tone if the "System alert" in Pro files is activated.
3> During charging, the icon of battery status blinks until the charging completes.
Note: The actual standby time and call time depend on the operation, local network, and settings of
the SIM card and mobile phone.

Using battery

The performance of the battery is affected by various factors, including wireless network settings,
signal intensity, environment temperature, the function or settings that you select, accessories and the
mode of voice, data or other applications that you select.
To keep the battery in optimum performance, please follow the rules below:
 The charging of new battery or batteries which haven't been used for long time may be longer;
 Keep the battery in room temperature when it is being charged;
 It is normal that the charging time becomes longer after long time using. If the call time becomes
shorter and charging time becomes longer after normal charging, you need to change a quali fied
battery. Unquali fied battery may damage your phone and cause danger.
 If the battery is left unused for too long time or the battery voltage is too low, it takes certain period
of time to display the charging interface normally when the charger is connected.
Note: To protect your safety and the environment, do not dispose the battery randomly.
Warning: The short circuit of battery may cause explosion, fire or body hurt.
10

Advertisement

Table of Contents
loading

Related Products for Techmade TECH SMART POCKET 280

Table of Contents