Summary of Contents for QUAD 195D
- Page 1 QUAD195 QUAD195D MULTI-CHANNEL WIRELESS SYSTEM WITH RF/POWER DISTRIBUTION OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM...
-
Page 2: Table Of Contents
QUAD195/D INTRODUCTION The design of Lectrosonics Quad Pak systems has evolved over the years as a result of suggestions garnered during many conversations with industry sound mixers and production engineers. These suggestions, together with meticulous attention to de sign and construction details, have resulted in a system that offers portability, versatil... -
Page 3: General Technical Description
Multi-channel Wireless System GENERAL TECHNICAL DESCRIPTION The QUAD195 consists of two sub-systems; the housing which contains the gel-cell power supply and the RF/power distribution module/s. The housing is constructed of machined aluminum. A strap handle is bolted directly to the top panel of the housing for ease of carrying. - Page 4 QUAD195/D ANTENNA LEADS - These BNC terminated leads provide isolated RF signals for each receiver installed in the sys tem. ANTENNA - The helical antenna provided with the unit attaches to this BNC connector directly with a twist lock mo tion.
-
Page 5: Rear Panel Description
Multi-channel Wireless System REAR PANEL DESCRIPTION SERIAL/FREQUENCY LABEL - This label indicates the serial number of the distribution module. It also indicates the RF pass-band of the unit. IMPORTANT - The receivers installed in the unit must fall between the frequencies indicat ed on the label. -
Page 6: Operating Instructions
QUAD195/D The QUAD195 is designed to contain up to four receivers. Installation of these receivers is quite simple. First, loosen but do not remove, the two large counter-sunk phillips head screws in the front panel and the two in the rear panel of the housing. -
Page 7: Specifications
Multi-channel Wireless System SYMPTOM POSSIBLE CAUSE NO POWER LEDs OR AUDIO 1) Power switch in the OFF position. Switch to MAIN/EXT. POWER LED LIGHTS ON CDM4 1) Power leads in back not connected to receivers. BUT NO LIGHTS ON RECEIVERS Check power connections. -
Page 8: Service And Repair
QUAD195/D RF Gain: 1.5 dB RF Output: Four outputs, 50 Ohm, BNC Filtering: Two section helical resonator Third Order Intercept: +25 dBm Power Input: 12 to 20 Vdc (either polarity) Pins 1 and 4 on XLR power jack CH-50 adapter for AC operation 14 to 20 Vac, 50/60 Hz, 1/2 Amp Pins 2 and 3 on XLR power jack 16 to 22 Vdc 1/2 Amp... -
Page 9: Returning Units For Repair
Multi-channel Wireless System We strongly recommend that you do not try to repair the equipment yourself and do not have the local repair shop attempt anything other than the simplest repair. If the repair is more complicated than a broken wire or loose connec tion, send the unit to the factory for repair and service. -
Page 10: Warranty
LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was purchased from an authorized dealer. This warranty does not cover equipment which has been abused or damaged by careless handling or shipping.