Fellowes POWERSHRED DS-1200Cs Instructions Manual page 2

A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, credit cards, staples, small paper clips and junk mail
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, CD/DVDs,
cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut ......................................................................................................4mm x 50mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
the instruction manual. Read the entire instruction manual before
operating shredders.
entry. Always set to off or unplug when not in use.
from shredder openings. If object enters top opening, switch to
Reverse (R) to back out object.
Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
Do not place near or over heat source or water.
BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after
each pass to clear entry. Continuous
operation beyond 5 minutes will
trigger a 30-minute cool down period.
2
F.
G.
H.
KEY
A. SafeSense
B. Paper/Card entry
C. Handle
D. Window
PAPER/CARD
1 2
Plug in and put
Set to Auto On (I)
disconnect power
switch in ON (I) position
® Technology E. Pull-out Bin
F. Disconnect power switch
1. OFF
2. ON
G. See safety instructions
Maximum:
Sheets per pass ........................................................................................................... 12*
Cards per pass ............................................................................................................... 1*
Paper entry width .................................................................................................. 225mm
* A4 (70g), paper at 220-240V, 50/60 Hz, 2.45Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 120 sheets;
10 credit cards. 12 sheets per pass to avoid jams.
Fellowes SafeSense ® shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
This shredder has a Disconnect Power Switch (F) that must be in the ON (I)
position to operate shredder. In case of an emergency move switch to OFF (O)
position. This action will stop shredder immediately.
and easily accessible. Energy converters, transformers, or extension cords should
not be used with this product.
3 4
Feed paper/card When finished
straight into paper shredding set to
entry and release OFF (O)
ENGLISH
Model DS-1200Cs
H. Control Switch and Indicator lights
R 1. Reverse
O 2. OFF
I 3. Auto-On (green)
4. Overheat (red)
5. SafeSense ® indicator (yellow)