Beldray EH0089 Instruction Manual

Conception wall fire

Advertisement

Conception Wall Fire
Instruction Manual
THE SCIENCE
BEHIND CLEAN
www.beldray.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EH0089 and is the answer not in the manual?

Questions and answers

Summary of Contents for Beldray EH0089

  • Page 1 Conception Wall Fire Instruction Manual THE SCIENCE BEHIND CLEAN www.beldray.com...
  • Page 2: Safety Instructions

    Do not run the supply cord under carpets, rugs etc. or anywhere where it may present a trip hazard. Do not immerse the appliance or plug in water or any other liquid. Do not operate the appliance with wet hands. THE SCIENCE EH0089 Conception Wall Fire BEHIND HEAT...
  • Page 3 Warning: This appliance is not equipped with a device to control the room’s temperature. Do not use this appliance in small rooms whilst occupied by persons incapable of leaving the room on their own, unless constant supervision is provided. EH0089 Conception Wall Fire...
  • Page 4 Caution: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. Caution: Hot surface. Do not touch the hot section or heating components of the appliance. THE SCIENCE EH0089 Conception Wall Fire BEHIND HEAT...
  • Page 5 5 No.5 32 mm screws (for the wall fixing) Instruction manual Features 2000 W Two heat settings: 1000 W/ 2000 W Overheat protection Thermal cut-out device Flame effect setting Acrylic and white pebble bowl fuel bed Fully assembled contemporary design EH0089 Conception Wall Fire...
  • Page 6 1. Main body 2. Heating 1 switch 3. Heating 2 switch 4. Fan switch 5. On/Off switch 6. Hearth 7. Pebbles 8. Control panel 9. Translucent cover (underneath pebbles) 10. Fire bowl THE SCIENCE EH0089 Conception Wall Fire BEHIND HEAT...
  • Page 7: Instructions For Use

    STEP 4: The wall bracket needs to be mounted approximately 30 mm inwards from the outer edge of the fire surround to match the position of the fire brackets. Hold the wall brackets in place and carefully mark the positions of the screw holes onto the wall. EH0089 Conception Wall Fire...
  • Page 8 STEP 3: At the rear of the Conception Wall Fire at each side, there is a bracket (shown below). These brackets engage behind the wall mounted brackets to provide a secure fixing method that cannot be seen in normal use. THE SCIENCE EH0089 Conception Wall Fire BEHIND HEAT...
  • Page 9 STEP 14: Screw the t-shaped bracket to the wall. STEP 15: Slide the hearth back into place underneath the Conception Wall Fire. Note: It may be necessary to lift the fire slightly whist fitting the t-shaped bracket. EH0089 Conception Wall Fire...
  • Page 10 Note: Turning on the ‘Fan’ switch without turning on either of the ‘Heating’ switches will operate the Conception Wall Fire without heat. Note: Selecting the ‘Heating 2’ switch will have no effect on the Conception Wall Fire. THE SCIENCE EH0089 Conception Wall Fire BEHIND HEAT...
  • Page 11: Troubleshooting

    Conception Wall Fire is suspected to be faulty, have it checked by a qualified electrician. No light is being emiited from The bulb has blown. Check the bulb by the Conception Wall Fire. replacement. EH0089 Conception Wall Fire...
  • Page 12: Specifications

    Do not immerse the Conception Wall Fire in water or any other liquid. Specifications Product code: EH0089 Supply: 220–240 V ~ 50 Hz Power 2000 W Fuse: 13 A Lighting: 1 x clear 230 V 28 W SES E14 bulb THE SCIENCE EH0089 Conception Wall Fire BEHIND HEAT...
  • Page 13 Connection to the mains Please check that the voltage indicated on the product corresponds with your supply voltage. Important As the colours in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, please proceed as follows: The wires in the mains lead are coloured in accordance with the following code:...
  • Page 14 Telephone: +44 (0)161 934 2240* *Telephone lines are open Monday – Friday, 9am – 5pm (Closed Bank Holidays) Email: customersupport@beldray.co.uk Fax: 0161 628 2126 Please have your delivery note to hand as details from it will be required. If you wish to return this product please return it to the retailer from where it was purchased with your receipt (subject to their terms and conditions).
  • Page 15 Express Gifts Ltd., BBS 4EE. UK. © 2014 Beldray Trademark. All rights reserved. Please retain all instructions for future reference. Made in China. CD070514/MD000000/V1...

Table of Contents