Scientific Atlanta Explorer 2100 User's Installation Manual page 15

Digital home communications terminals
Table of Contents

Advertisement

Optional Devices,
continued
VCR
OUT TO
IN FROM
TV
ANT.
ANTENNA
6
MODEL E2051-X01
TO
TV
CABLE
OUT
CABLE
FROM
IN
5
VCR
BYPASS
Bypass Module Attached to
EXPLORER DHCT
5 Align the mounting tabs with the screw holes.
Tighten the screws; do not overtighten.
6 Connect to your TV and VCR.
7 Connect your cable input from the wall.
8 Connect any additional devices, if applicable.
9 Do you have other devices to connect?
• If yes, see page 9 to locate other connec-
tion diagrams appropriate for your system.
• If no, plug in the power cord to an AC
power outlet.
TV
Cable Input
From Wall
CABLE/
7
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CABLE
THIS DEVICE IS INTENDED TO BE ATTACHED
TO A RECEIVER THAT IS NOT USED TO
INPUT
RECEIVE OVER-THE-AIR BROADCAST
120 VAC
120 VAC
SIGNALS. CONNECTION OF THIS DEVICE
IN ANY OTHER FASHION MAY CAUSE
60Hz 5A
60Hz 40W
HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS AND IS IN VIOLATION
OF THE FCC RULES, PART 15.
T8754
Activating and Deactivating RF Bypass
If your remote control includes a Bypass key, follow these
instructions to use the Bypass feature.
To activate the Bypass feature, press the Bypass
key. The Bypass indicator illuminates on the DHCT.
Notes:
• You can only view analog channels; digital channels are
not available while the Bypass feature is active. (Verify
with your cable service provider which channels are
analog and which channels are digital.)
• Use the Bypass key to toggle the feature on and off.
To deactivate the Bypass feature:
1. Press the Bypass key on the remote control. The Bypass
indicator no longer illuminates on the Explorer DHCT.
2. Tune your TV using one of the following methods:
• If the TV/VCR switch on your VCR is in the VCR
position, you must tune your TV to the VCR output
channel (channel 3 or 4). You can view a tape, or you can
view the channel to which the Explorer DHCT is tuned.
• If the TV/VCR switch on your VCR is in the TV position,
you must tune your TV to the Explorer DHCT's output
channel (channel 3 or 4). You can only view programs
from the Explorer DHCT, regardless of what your VCR is
playing.
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Explorer 3100

Table of Contents